Abstract:Vast quantities of natural gas occur naturally as hydrates in permafrost and oceanic margin zones. Injection of CO2 and of flue gas into these hydrates and hydrate bearing rock has been suggested as a means of storing this greenhouse gas. This storage method has potentially the additional benefit of simultaneously producing methane gas in a so-called “swapping” process. In this work we quantitatively investigate the swapping behavior from injection of pure carbon dioxide and the (CO2 + N2) binary gas mixture through artificial hydrate-bearing sandstone samples by use of a coreflooding experimental apparatus. Several experiments were performed to examine the influence of operating conditions on methane production by CO2 or (CO2 + N2) injection in the temperature range of 274.15−277.15 K and 7.039−10.107 MPa pressure range. Our results show that the use of the (CO2 + N2) binary gas mixture is advantageous compared to the use of pure carbon dioxide in swapping methane from its hydrate phase; the methane recovery efficiency in brine water systems is enhanced relative to pure water systems. The replenishment of a fresh (CO2 + N2) gas mixture into the vapor phase can be considered as an efficient extraction method because 46.32% of methane was displaced from its hydrate phase with the (CO2 + N2) binary gas mixture after 341.75 h of exposure to the (CO2 + N2) gas mixture. During the CH4 – (CO2 + N2) swapping process, gas chromatography analysis and calculations demonstrated that nitrogen molecules can take the place of some methane in small hydrate cages, as long as the equilibrium formation pressure of (CO2 + N2) binary gas hydrate is below that of methane hydrate, even though adding nitrogen to carbon dioxide reduces the thermodynamic driving force for the formation of a new hydrate. When other conditions are similar, the methane gas recovery efficiency increases with the increase of the driving force for the swapping process. The swapping of methane with carbon dioxide in hydrates also requires a better understanding of the thermodynamic characteristics of CH4 and CO2 hydrates as well as (CH4 + CO2) or (CH4 + CO2 + N2) mixed hydrates if the (CO2 + N2) gas mixture is to be used as the swapping gas), along with the thermophysical property changes during gas exchange. In this study we have also used a high pressure micro-differential scanning calorimetry (HP-DSC) to investigate the dissociation behavior of various hydrates. The hydrate dissociation enthalpies were determined by both DSC measurements and modelled using the Clapeyron equation. For the single guest molecule hydrate system, the average dissociation enthalpies of CH4 hydrate and CO2 hydrate measured by integrating the endothermic peak area for a calorimetry scan are 55.01 kJ/mol and 58.96 kJ/mol, respectively, which are very close to the values calculated by the Clapeyron equation. However, in the multicomponent guest hydrates system, the DSC measured dissociation enthalpies of the (CH4 + CO2) binary hydrates and the (CH4 + CO2 + N2) ternary hydrates are slightly higher than that calculate by the Clapeyron equation. It was found that the mixture dissociation enthalpies are located between the limiting values of pure CH4 hydrate and CO2

CO2 Storage Behavior Via Forming Hydrate from N2/CO2 Gas Mixtures in the Presence of Initial SI CO2 Hydrate Seeds

Numerical Investigation of CO2 Storage Capacity Via Hydrate in Deep-Sea Sediments

Molecular Dynamics of Carbon Sequestration Via Forming CO2 Hydrate in a Marine Environment

Molecular Dynamics of Carbon Sequestration via Forming CO 2 Hydrate in a Marine Environment

Optimized Strategies for Efficient CO2 Trapping Using Hydrate Technology by Pressure Adjustment

Enhanced CO2 Sequestration Based on Hydrate Technology with Pressure Oscillation in Porous Medium Using NMR

CO2/N-2 Mixture Sequestration in Depleted Natural Gas Hydrate Reservoirs

Formation and storage characteristics of CO2 hydrate in porous media: Effect of liquefaction amount on the formation rate, accumulation amount

Study on Carbon Storage by CO<sub>2</sub> Hydrate Formation in the Ion-Containing Environment

Dependence of the hydrate-based CO2 storage process on the hydrate reservoir environment in high-efficiency storage methods

CO2 Storage in Deep Oceanic Sediments in the form of Hydrates: Energy Evaluation and Advantages Related to the Use of N2-Containing Mixtures

Experimental Study on the Flux-Controlled Growth of CO2-SO2 Hydrates: Implications for Hydrate-Based CO2 Sequestration

Numerical Simulation of CO2 Utilization As Hydrates in Depleted Natural Gas Hydrate Formation

Behaviors of CO<sub>2</sub> Hydrate Formation in the Presence of Acid-Dissolvable Organic Matters

Numerical Investigation of CO2 Sequestration As Hydrates in Produced Natural Gas Hydrate Formation with Different Intrinsic Permeability and Water Saturation Conditions

CO2 Hydrate Formation Characteristics Inside Seawater Residual/saturated Sediments under Marine CO2 Storage Scenes

Molecular Insights into the Formation of Carbon Dioxide Hydrates on the External Surface of Sodium Montmorillonite in the Presence of Various Types of Organic Matters

Molecular Insights into the Microscopic Behavior of CO2 Hydrates in Oceanic Sediments: Implications for Carbon Sequestration

CO 2 storage by hydrate swapping – flooding experiments , thermal dissociation behavior and dissociation enthalpies

Compressibility, thermal expansion coefficient and heat capacity of CH4 and CO2 hydrate mixtures using molecular dynamics simulations.

Nucleation and dissociation of carbon dioxide hydrate in the inter- and intra-particle pores of dioctahedral smectite: Mechanistic insights from molecular dynamics simulations