Abstract:NHR200-II is a 200 MW nuclear heating reactor. The integrity of the fuel assembly should be ensured during the normal operations and design basis accidents. In the latter cases (e.g. earthquake), its deformation or damage should not prevent the insertion of control rods to shut down the reactor. Meanwhile, during the operating time, there are two aspects that attention should be paid, (i) the mechanical performance of internal core materials might be worsened by the increase of burnup and (ii) dynamic loads involving hydraulic erosion, flow-induced vibration might damage the assemblies. Therefore, the investigation of the dynamic characteristics of the fuel assembly with consideration of burnup effects is necessary. The fuel rod with pellets and cladding was approximated by the beam elements with a circular cross-section applied with calibrated material properties. Connector elements were used to replace the three-arc springs and dimples on the grid and thus simplify the geometry of the spacer grid. The agreements between the detailed and simplified models indicate the equivalence of these two methods. Then two simulations were performed to evaluate the dynamic characteristics of NHR200-II fuel assembly at the beginning of life. The modal simulation of the fuel bundle and channel suggests that the channel could be assumed stationary to the fuel bundle during the dynamic analysis. The seismic simulation conducted in the specific boundary conditions indicates that the integrity of spacer grids can be guaranteed and there was no buckling of the gird. No permanent deformation of the channel was observed, and its relative displacements were sufficiently small to ensure the insertion of control rods. Finally, burnup effects on the structural behavior of the fuel rod are discussed. The initial conditions of NHR200-II fuel assembly and its material properties at different burnup times are provided by referring to two irradiated tests. Various sensitivity analyses had been conducted to evaluate the effects of material properties and pellet-cladding interaction on the resulting failure limit and stiffness of the fuel rod.

Investigation on fuel cracking induced relocation behavior of dual-cooled annular fuel based on finite element simulation

Investigation on Axial Relocation of Fragmented Annular Fuel under Loss of Coolant Accident Conditions with Discrete Element Method

Numerical Simulation of Fuel Relocation at High Burnup with Discrete Element Method

A three-dimensional axial fuel relocation framework with discrete element method to support burnup extension

THREE-DIMENSIONAL SIMULATION OF FUEL DISPERSAL AT HIGH BURNUP

Development of a Thermal–mechanical Behavior Coupling Analysis Code for a Dual-Cooled Annular Fuel Element in PWRs

Simulation of the In-Pile Behaviors Evolution in Nuclear Fuel Rods with the Irradiation Damage Effects

Three-dimensional Simulation of Fuel Relocation During Loss-of-coolant Accidents Based on the Coupled FEM-DEM Approach

The critical influencing factors responsible for the particle cracking in UMo/Zr dispersion fuel plates during post-irradiation anneal tests

Numerical Simulation Research on the Irradiation-Thermal-Mechanical Performance Evolution of FCM Fuel

Modeling Axial Relocation of Fragmented Fuel During Loss of Coolant Conditions by Using ABAQUS

Mechanical Behaviors of the Dispersion Nuclear Fuel Plates Induced by Fuel Particle Swelling and Thermal Effect I: Effects of Variations of the Fuel Particle Volume Fractions

Simulation of the coupling behaviors of particle and matrix irradiation swelling and cladding irradiation growth of plate-type dispersion nuclear fuel elements

Thermo-mechanical Behavior Simulation Coupled with the Hydrostatic-Pressure-dependent Grain-Scale Fission Gas Swelling Calculation for a Monolithic UMo Fuel Plate under Heterogeneous Neutron Irradiation

Three-dimensional FE analysis of the thermal-mechanical behaviors in the nuclear fuel rods

Investigation on the Irradiation-thermal–mechanical Coupling Behaviors of the Solid Microencapsulated Fuel Rod

Effects of heterogeneous distribution of fuel particles on the irradiation-induced mechanical behaviors in the dispersion nuclear fuel plate

STUDY ON THE DEGRADATION BEHAVIORS OF ANNULAR FUEL UNDER SEVERE ACCIDENT

Simulation of Dynamic Characteristics of NHR200-II Fuel Assembly

Preliminary Development of a Multi-Physics Coupled Fuel Performance Code for Annular Fuel Analysis under Normal Conditions

Hydrostatic Pressure Effect of Fission Gas Swelling in UMo/Al Dispersion Fuel Plate