Abstract:Abstract A radiofrequency (RF) ion source with a megawatt power extraction, thunder I, has been developed for the neutral beam injector (NBI) on HL-2A tokamak. A full solid-state RF generator with output power of 80 kW and frequency of 2 MHz was built by an RF combiner using 8 modules of solid-state RF generator with power of P RF = 10 kW. The line electric efficiency of whole RF generator reaches 92% and its voltage standing wave ratio (VSWR) is 1.01, thus no water-cooling system is supplied. A quartz vessel with the inner diameter of 250 mm is directly adopted for resisting atmospheric pressure, which can dramatically simplify source structure. Nowadays, the extracted beam parameters of RF hydrogen ion source are 32 kV/20 A/0.1 s on a test bed, while the design parameters are 50 kV/20 A/3 s. The beam density profile measured by the infrared imaging technique at 1.3 m downstream from the grounded grid obeys a Gaussian distribution, and the corresponding half width of 1/ e power decay at the matched condition is about 80 mm. Plasma homogeneity is over 90% at low RF power. The beam divergence angle meets the requirement of NBI system on HL-2A tokamak. The extractable current density increases almost linearly with the RF power. It reaches 2400 A m −2 at P RF = 32 kW. The ion density in front of plasma grid is about 1 × 10 18 m −3 , corresponding to an ionized fraction of about 1% at the gas pressure of 0.5 Pa. Single hydrogen ion fraction reaches 79% at the beam current of 12.4 A. Some improvements have been considered for optimizing ion source performance on next experimental campaign. One smaller auxiliary RF discharge chamber equipped with a gas feed path, driven by 13.56 MHz/3.5 kW generator, is connected to main discharge chamber driven by 2 MHz/40 kW generator. By this dual-driven configuration, the innovative RF plasma source with high-pressure density gradient solves the initial ignition problem of powerful RF ion source even if the gas pressure below 0.1 Pa. In addition, the RF negative hydrogen ion source of 200 kV/20 A/3600 s is also developed at SWIP for the China fusion engineering test reactor.

Optimization of transverse emittance for RF-driven negative hydrogen ion source developed at China Spallation Neutron Source

Plasma Impedance Measurement of Uncesiated RF-driven Negative Hydrogen Ion Source in CSNS

RF H-Minus Ion Source Development in China Spallation Neutron Source

Beam Optimization of Helium Injector for Coupled RFQ–SFRFQ Linac

Radio frequency design and multipacting study of superconducting elliptical cavity for CSNS-II linac

Preliminary Design of CSNS-II Linac SRF LLRF

Development of megawatt radiofrequency ion source for the neutral beam injector on HL-2A tokamak

Measurement of Emittance at CSNS Ion Source Without Analyzing Magnet

A 2.45 Ghz Electron Cyclotron Resonance Proton Ion Source and A Dual-Lens Low Energy Beam Transport

Study on the injection optimization and transverse coupling for CSNS/RCS

Design and Optimization Study of a Duoplasmatron Ion Source for High-Intensity Proton Beam

Structure design and analysis of RF ion source for negative ion source test facility

Design of a compact RFQ linac for the transportable neutron source

Beam Dynamics Optimization of Very-High-frequency Gun Photoinjector

Analysis of Slice Transverse Emittance Evolution in a Very-High-frequency Gun Photoinjector

Rms emittance measures for solenoid transport and facility for rare isotope beams front-end simulations

RF Simulation and Improvements of an Ion Source Test Facility at HUST

Beam Dynamics and Commissioning of CW RFQ for a Compact Deuteron–beryllium Neutron Source

Construction of External Antenna RF H-minus Source in CSNS

Design of Power Supply System for the Prototype Rf-Driven Negative Ion Source for Neutral Beam Injection Application

Physics and engineering design of 400 keV H- accelerator for negative ion based neutral beam injection system in China