Abstract:Rapid, simultaneous detection of organic chemical pollutants in water is an important issue to solve for protecting human health. This study investigated the possibility of developing an in situ reusable optical sensor capable of selective measurements utilizing a chalcogenide transducer supplemented by a hydrophobic polymer membrane with detection based on evanescent waves in the mid-infrared spectrum. In order to optimise a polyisobutylene hydrophobic film deposited on a chalcogenide waveguide, a zinc selenide prism was utilized as a testbed for performing attenuated total reflection with Fourier-transform infrared spectroscopy. To comply with the levels mentioned in health guidelines, the target detection range in this study was kept rather low, with the concentration range extended from 50 ppb to 100 ppm to cover accidental pollution problems, while targeted hydrocarbons (benzene, toluene, and xylene) were still detected at a concentration of 100 ppb. Infrared measurements in the selected range showed a linear behaviour, with the exception of two constantly reproducible plateau phases around 25 and 80 ppm, which were observable for two polymer film thicknesses of 5 and 10 μm. The polymer was also found to be reusable by regenerating it with water between individual measurements by increasing the water temperature and flow to facilitate reverse exchange kinetics. Given the good conformability of the hydrophobic polymer when coated on chalcogenide photonic circuits and its demonstrated ability to detect organic pollutants in water and to be regenerated afterwards, a microfluidic channel utilising water flow over an evanescent wave optical transducer based on a chalcogenide waveguide and a polyisobutylene (PIB) hydrophobic layer deposited on its surface was successfully fabricated from polydimethylsiloxane by filling a mold prepared via CAD and 3D printing techniques.

Titelbild: IR‐ATR Chemical Sensors Based on Planar Silver Halide Waveguides Coated with an Ethylene/Propylene Copolymer for Detection of Multiple Organic Contaminants in Water (angew. Chem. 8/2013)

IR‐ATR Chemical Sensors Based on Planar Silver Halide Waveguides Coated with an Ethylene/Propylene Copolymer for Detection of Multiple Organic Contaminants in Water

A Fluorescent Ratiometric Sensor Based on Covalent Immobilization of Chalcone Derivative and Porphyrin Zinc for Detecting Water Content in Organic Solvents

Innentitelbild: Layer‐by‐Layer Assembled Conductive Metal–Organic Framework Nanofilms for Room‐Temperature Chemiresistive Sensing (angew. Chem. 52/2017)

Titelbild: Toward Wearable Sensors: Fluorescent Attoreactor Mats As Optically Encoded Cross‐Reactive Sensor Arrays (angew. Chem. 10/2012)

Direct Detection of Dilute Solid Chemicals with Responsive Lateral Organic Diodes

An optical fibre sensor for remotely detecting water traces in organic solvents

Titelbild: Stabilizing Two Classical Antiaromatic Frameworks: Demonstration of Photoacoustic Imaging and the Photothermal Effect in Metalla‐aromatics (Angew. Chem. 21/2015)

Determination of Chlorinated Hydrocarbons in Water Using Highly Sensitive Mid-Infrared Sensor Technology

Titelbild: Metal–Organic Frameworks with Target‐Specific Active Sites Switched by Photoresponsive Motifs: Efficient Adsorbents for Tailorable CO <sub>2</sub> Capture (Angew. Chem. 20/2019)

Surface functionalization of a chalcogenide IR photonic sensor by means of a polymer membrane for water pollution remediation

A Colorimetric Sensor Array for Organics in Water

Soluble Polymeric Dual Sensor for Temperature and pH Value

Innenrücktitelbild: Van Der Waals Heterostructured MOF‐on‐MOF Thin Films: Cascading Functionality to Realize Advanced Chemiresistive Sensing (angew. Chem. 42/2019)

High-sensitivity infrared attenuated total reflectance sensors for in situ multicomponent detection of volatile organic compounds in water

Surface Functionalization of Ion-in-conjugation Polymer Sensors for Humidity-Independent Gas Detection at Room Temperature

Fluorimetric Detection of Vapor Pollutants with Diketopyrrolopyrrole Polymer Microcavities

Beyond Karl Fischer titration: a monolithic quantum cascade sensor for monitoring residual water concentration in solvents

Highly Sensitive Pyrene–dansyl Conjugate-Based Fluorescent Sensor for Discriminative Detection of Water in Organic Solvents

Dual-Phase Emission AIEgen with ICT Properties for VOC Chromic Sensing

Water Detection in Organic Solvents Using a Copolymer Membrane Immobilised with a Fluorescent Intramolecular Charge Transfer-Type Dye: Effects of Intramolecular Hydrogen Bonds