Abstract:<p>In selective laser melting in additive manufacturing, powder spreading significantly affects the subsequent operating procedure as well as the quality of final products. Compared with large amount of previous work on powder spreading on a flat substrate surface before printing, in this article, 3D particulate scale dynamic simulations were carried out to study the spreading of 316 L stainless steel powder during printing by using discrete element method (DEM). The influences of various factors including processing parameters, blade shape, and the powder size on the quality of the spread powder bed were investigated in terms of both macroscopic packing density/uniformity and microstructure/micro dynamics. And optimized condition was identified. The mechanisms were also analyzed based on the powder behavior and forces caused by cooperative interaction between the formed zone (printed part) and the already packed powder layer. The results show that the blade moving speed can seriously influence the quality of the spread powder bed; normally the smaller the blade moving speed, the higher the powder bed quality, but the lower the working efficiency. Therefore, through comprehensive consideration, the proper blade moving speed is chosen to be 0.1 m/s. Increasing the blade gap height or decreasing the particle size (i.e., <em>D</em> = 30 µm) will increase the average relative packing density and structure uniformity. The angle of 15° for the blade is proved to be optimal for excellent powder spreading. Through simulation under optimized parameters, it can be found that the spread powder layer can be more uniform and much denser with high efficiency. And both macroscopic and microscopic analyzes indicate that the spread powder bed has desired structure and property. These findings can improve the fundamental understanding on the powder spreading and provide valuable references for the formation of high quality powder bed during 3D printing.</p>

Modeling and Simulation of Powder Spreading of Inconel 625 Based on 3DP Process

Powder spreading, densification, and part deformation in binder jetting additive manufacturing

DEM powder spreading and SPH powder melting models for additive manufacturing process simulations

Discrete Element Simulation of the Effect of Roller-Spreading Parameters on Powder-Bed Density in Additive Manufacturing

Quantitative analysis of thin metal powder layers via transmission X-ray imaging and discrete element simulation: Roller-based spreading approaches

Simulation of Forming Process of Powder Bed for Additive Manufacturing

Dynamic investigation on the powder spreading during selective laser melting additive manufacturing

Investigating the effect of temperature on powder spreading behaviour in powder bed fusion additive manufacturing process by Discrete Element Method

Effect of powder morphology on flowability and spreading behavior in powder bed fusion additive manufacturing process: a particle-scale modeling study

Process Mechanisms Based on Powder Flow Spatial Distribution in Direct Metal Deposition

Effects of spreader geometry on powder spreading process in powder bed additive manufacturing

Numerical simulation of the flow behavior and powder spreading mechanism in powder bed-based additive manufacturing

Spreading Behavior of Non-Spherical Particles with Reconstructed Shapes Using Discrete Element Method in Additive Manufacturing

Spatial Mapping of Powder Layer Density for Metal Additive Manufacturing via X-ray Microscopy

Numerical insights on the spreading of practical 316 L stainless steel powder in SLM additive manufacturing

Powder deposition mechanism during powder spreading with different spreader geometries in powder bed fusion additive manufacturing

Discrete Element Modeling of Scraping Process and Quantification of Powder Bed Quality for SLM

Binder Jetting Additive Manufacturing of Ceramics: Analytical and Numerical Models for Powder Spreading Process

Packing Quality of Powder Layer During Counter-Rolling-type Powder Spreading Process in Additive Manufacturing

Influence of powder characteristics on microstructure and mechanical properties of Inconel 718 superalloy manufactured by direct energy deposition

Three-Dimensional Combined Finite-Discrete Element Approach for Simulation of Single Layer Powder Compaction Process