Abstract:Photomultiplier tubes (PMTs) are widely used in astroparticle physics experiments to detect light flashes (e.g. fluorescence or Cherenkov light) from extensive air showers (EASs) initiated by statistically rare very high energy cosmic particles when travelling through the atmosphere. Their high amplification factor (gain) allows the detection of very low photon fluxes down to single photons. At the same time this sensitivity causes the gain and signal-to-noise ratio to decrease with collected charge over the lifetime of the PMT (referred to as "ageing"). To avoid fast ageing, many experiments limit the PMT operation to reasonably low night sky background (NSB) conditions. However, in order to collect more event statistics at the highest energies, it is desirable to extend the measurement cycle into (part of) nights with higher NSB levels. In case the signal-to-noise ratio remains large enough in the subsequent reconstruction of the EAS events, lowering the PMT gain in such conditions can be an option to avoid faster ageing. In this paper, performance studies under high NSB with Photonis XP3062 PMTs, as used in the fluorescence detector of the Pierre Auger Observatory, are presented. The results suggest that lowering the PMT gain by a factor of 10 while increasing the NSB level by a similar factor does not significantly affect the PMT performance and ageing behaviour so that detection and offline reconstruction of EASs are still possible. Adjusting the PMT gain according to a changing NSB level throughout a night has been shown to be possible and it follows a predictable behaviour. This allows to extend the measurement cycles of experiments, based on PMTs of type Photonis XP3062 or comparable and exposed to the NSB, to enhance the sensitivity especially at the highest energies where events are very rare.

Characterization of the Photomultiplier Tube for the LHAASO Electromagnetic Particle Detector

Characterization of HZC XP1805 photomultiplier tube for LHAASO-WCDA with a high dynamic range base

High dynamic range base design and characterization of an 8-inch photomultiplier tube CR365-02-2 for the LHAASO-MD experiment

Setup of a photomultiplier tube test bench for use at LHAASO-KM2A

Photomultiplier Tube Selection for the Wide Field of View Cherenkov/fluorescence Telescope Array of the Large High Altitude Air Shower Observatory

The Photon Detection Mode of Photomultiplier Tubes Considering the Pulse Height Distribution

Characterization of the Hamamatsu 8-inch R14688-100 PMT

Development and Characterization of Sub-100 Ps Photomultiplier Tubes.

Characterization of the Hamamatsu R11780 12 inch Photomultiplier Tube

Studies of A Solid Detector Array for High Energy X-Ray Imaging System Based on Ma-Pmt

Study on the Performance of Electromagnetic Particle Detectors of Lhaaso-Km2a

Performance testing of a novel short axis photomultiplier tube for the HUNT project

Improvement on the Linearity Response of PandaX-4T with new Photomultiplier Tubes Bases

Improvement on the Linearity Response of PandaX-4T with New Photomultiplier Tube Bases

A photomultiplier tube test stand and on-site measurements to characterise the performance of Photonis XP3062 photomultiplier tubes at increased background light conditions and lower gain

A New Compact Position-Sensitive PMT for Scintillation Detectors

Characterization of Large Area Photomultiplier ETL 9357FLB for Liquid Argon Detector

Development of Low Radioactivity Photomultiplier Tubes for the XMASS-I Detector

All in One Integrated Smart Photomultiplier Tube Readout Electronics with Gigabit Ethernet and PoE