Abstract:Background When conducting experiments at a synchrotron radiation facility, it is necessary to scan the position of the sample or the beam energy within a certain range. The scanning modes are categorized as step scanning and on-the-fly. In the step-scanning mode, there is a significant amount of dead time in the motion mechanism, which leads to long data acquisition times and low experimental efficiency. By contrast, the on-the-fly mode allows for continuous motion while triggering the detectors and sensors, avoiding the dead time of the motion mechanism and greatly improving the efficiency of the experiments. Purpose This study aims to propose and implement a hardware-triggered on-the-fly system to achieve rapid and continuous scanning during experimental processes for Hefei light source (HLS). Methods The proposed on-the-fly system mainly consisted of a synchronous signal acquisition module, a synchronous motion control module, and a software control module. The design of the hardware synchronous trigger module in the synchronous signal acquisition module was based on the field-programmable gate array (FPGA) development board Zynq7020. The encoder signals were decoded into position signals and used to trigger other devices based on position or time. This made it the central component for the on-the-fly mode. The design of the synchronous motion control module was based on a highly synchronous EtherCAT bus. The motion controller supported multi-axis coordination and programmable trajectory motion to meet the requirements of different experiments. The software control module utilized the experimental physics and industrial control system (EPICS) architecture for device control, and experiment flow control and data acquisition were implemented using Bluesky platform. Finally, the proposed on-the-fly system has been deployed and tested at the Soft X-ray Magnetic Circular Dichroism (XMCD) experimental station of HLS. Results The experimental results demonstrate that the on-the-fly mode system not only meets the spectral performance requirements, but also reduces the single acquisition time from tens of minutes in the step-scanning mode to approximately 1 min. Conclusions Therefore, the on-the-fly system designed and implemented in this study significantly improves the experimental efficiency and user experience.

Development of experimental data management system for HLS-Ⅱ based on SciCat

The design of a scientific data management system based on DOMAS at CSNS-II (preliminary stage)

Automatic data archiving and visualization at HLS-II

Aquarium: an Automatic Data-Processing and Experiment Information Management System for Biological Macromolecular Crystallography Beamlines

Research and Implementation of Scientific Computing Metadata

DOMAS: a data management software framework for advanced light sources

Data management and analysis of HLS control system

Data-collection System for High-Throughput X-ray Absorption Fine Structure Measurements

Development of On-the-fly Mode Control System for Hefei Light Source

Design and Implementation of Metadata Management System

Distributed data processing and analysis environment for neutron scattering experiments at CSNS

The Status of Hls Control System

A data management system for machine learning research of tokamak

Developing CIMA-based cyberinfrastructure for remote access to scientific instruments and collaborative e-research

A distributed data processing scheme based on Hadoop for synchrotron radiation experiments

SAS-cam : a program for automatic processing and analysis of small-angle scattering data

Progress of Scientific Data Grid of Chinese Academy of Sciences

A customizable data management framework for high-repetition-rate high-energy-density science

Supporting High-Performance and High-Throughput Computing for Experimental Science

The Data Acquisition and Software Monitoring System for 4.6 GHz LHCD

The Operation Status of Hls (hefei Light Source)