Abstract:In the current study, thermal boundary conditions are considered in a rotating smooth channel with a square cross-section to investigate the secondary flow and compare it to that of the same channel without heating. The measurement is conducted at three streamwise planes (X=445 mm, 525 mm, 605 mm). The flow parameters are the Reynolds number (Re=4750, which was based on the average longitudinal or primary velocity U and the hydraulic diameter D of the channel cross-section), the rotation number (Ro=ΩD/U, where Ω is the rotational velocity, ranging from 0 to 0.26), and the aspect ratio of the channel cross-section (AR=1, which is calculated by dividing the channel height by the channel width). The leading and trailing walls are heated under a constant heat flux qw=380 W/m2, and the top and bottom walls are isothermal at room temperature. This work is in a series with our previous work without thermal boundary conditions. Based on the experimental data, we obtained a four-vortex regime. There is a counter-rotating vortex pair near the leading side and the trailing side. Because the leading and trailing walls are heated, the buoyancy force increases the relative vertical position of the vortex pair near the trailing side from 5% to 12.5% of the hydraulic diameter. When moving upstream along the streamwise direction, the upper vortex near the trailing wall becomes weaker, whereas the lower vortex becomes stronger. As the rotational speed increases, the vortex pair near the trailing side is inhibited by the Coriolis force. Under heated thermal boundary conditions, the vortex pair near the trailing side reappears due to the effect of buoyancy force. These results indicate that the buoyancy force has a substantial effect on the secondary flow regime under thermal boundary conditions.

Temperature and Velocity Characteristics of Rotating Turbulent Boundary Layers under Non-Isothermal Conditions

Turbulent Statistics and Flow Structures in Spanwise-Rotating Turbulent Plane Couette Flows

Equivalence of Three Thermal Boundary Conditions in Compressible Turbulent Channel Flows

Direct numerical simulation of turbulent channel flow with spanwise rotation

Hot-wire Experimental Investigation on Turbulent Prandtl Number in a Rotating Non-Isothermal Turbulent Boundary Layer

Experimental Investigation on Velocity and Temperature Field in a Rotating Non-isothermal Turbulent Boundary Layer Using Hot-wire

Effect of System Rotating on Turbulent Boundary Layer Flow

EXPERIMENTAL INVESTIGATION ON BOUNDARY LAYER FLOW UNDER THE EFFECT OF TEMPERATURE GRADIENT IN A SMOOTH ROTATING CHANNEL USING HOT-WIRE

Effect of Heat Flux on Boundary Layer Flow under Rotating Conditions

Interaction of Secondary Flow With Developing, Turbulent Boundary Layers in a Rotating Duct

Lattice-Boltzmann Investigation of Rotating Turbulence

Development of a Turbulent Boundary Layer in a Rotating Square Cross-Section Channel with Relatively High Local Rotation Parameter

Rotation Correction of Wall Function and Velocity Structure under the Couple Effects of Buoyancy Force and Rotating Effects at the Entry Section of the Smooth Straight Channel

Turbulent Characteristics and Rotation Correction of Wall Function in Rotating Channel with High Local Rotation Parameter

Study on transition to turbulence of rotating-disk boundary layer in a rotor-stator cavity with temperature gradient

Direct Numerical Simulation of Vertical Rotating Turbulent Open-Channel Flow with Heat Transfer

Fluid Flow and Convective Heat Transfer in a Rotating Helical Square Duct

Direct numerical simulation of turbulent heat transfer in an axially rotating pipe flow

Direct Numerical Simulation Of Turbulent Heat Transfer In An Axially Rotating Pipe Flow - Reynolds Shear Stress And Scalar Flux Budgets

Experimental Investigation of the Secondary Flow in a Rotating Smooth Channel Subjected to Thermal Boundary Conditions

Experimental Study of the Convective Mass-exchange Boundary Layer of a Rotating Cylindrical Surface