Time Parameter Mapping and Contour Error Precompensation for Multiaxis Input Shaping

Weixin Wang,Chuxiong Hu,Kai Zhou,Ze Wang

DOI: https://doi.org/10.1109/tii.2022.3158960

IF: 12.3

2023-01-01

IEEE Transactions on Industrial Informatics

Abstract:When the trajectory with high speed and high acceleration contains frequency contents matching with the structure mode, the inertial vibration of the structure is easily excited, reducing machining accuracy and surface finish. Input shaping can avoid vibration, but it introduces time-delay that causes multiaxis trajectory distortion and affects the accuracy of contour error estimation. This article presents time parameter mapping and contour error precompensation for multiaxis input shaping to suppress vibration. The mapping of time parameter domain of trajectories is established by deducing the relation between the local curvature extremums of the trajectories before and after shaping, which provides reference points for contour error estimation. The actual trajectory is predicted by the closed-loop servo dynamics model and reference trajectory, and then the Newton iterative algorithm based on time parameter mapping is used to seek the contour error point. Finally, the calculated contour error is low-pass filtered and projected to each axis, and then the shaped trajectory is precompensated to simultaneously reduce the contour error and avoid structural vibration. Comparative experiments are conducted to validate the effectiveness of the proposed method. Experimental results illustrate that the proposed method not only suppresses structural vibration, but also significantly improves the estimation accuracy and contouring performance by time parameter mapping.