Abstract:With the growing demand for FEL light sources, cost issues are being reevaluated. To make the machines more compact, higher frequency room temperature linacs are being considered, specifically ones using C-band (5.7 GHz) rf technology, for which 40 MV/m gradients are achievable. In this paper, we show that an X-band (11.4 GHz) linac using the technology developed for NLC/GLC can provide an even lower cost solution. In particular, stable operation is possible at gradients of 100 MV/m for single bunch operation and 70 MV/m for multibunch operation. The concern, of course, is whether the stronger wakefields will lead to unacceptable emittance dilution. However, we show that the small emittances produced in a 250 MeV, low bunch charge, LCLS-like S-band injector and bunch compressor can be preserved in a multi-GeV X-band linac with reasonable alignment tolerances. The successful lasing and operation of the LCLS [1] has generated world-wide interest in X-ray FELs. The demand for access to such a light source by researchers eager to harness the capabilities of this new tool far exceeds the numbers that can be accommodated, spurring plans for additional facilities. Along with cost, spatial considerations become increasingly important for a hard X-ray machine driven by amore » multi-GeV linac. The consequent need for high acceleration gradient focuses attention on higher frequency normal conducting accelerator technology, rather than the superconducting technology of a soft X-ray facility like FLASH. C-band technology, such as used by Spring-8, is a popular option, capable of providing 40 MV/m. However, more than a decade of R&D toward an X-band linear collider, centered at SLAC and KEK, has demonstrated that this frequency option can extend the gradient reach to the 70-100 MV/m range. The following design and beam dynamics calculations show an X-band linac to be an attractive choice on which to base an X-ray FEL.« less

Study of an L-Band CW Linac

Design, Fabrication, and Testing of an X-band 9-Mev Standing-Wave Electron Linear Accelerator

CRRFA-30 L Band Linac

Design of a 10 MeV normal conducting CW proton linac based on equidistant multi-gap CH cavities

Design and simulation of high power L-band multi-beam klystron

S-band high-gradient low single-periodic magnetically coupled standing-wave accelerating structure for a proton therapy linac

Design, Fabrication and Cold-Test of an X-band Accelerating Structure for Linearizer

Design and study of a continuous wave RFQ for the BISOL high intensity deuteron driver linac

Design of a CW high charge state heavy ion RFQ for SSC-LINAC

Development of A C-Band 6 Mev Standing-Wave Linear Accelerator

Suppression of beam break up instability on an S-band travelling-wave linac

Optimization and Measurement for an Electron Side-Coupled Linac with Longitudinally Off-Axis Coupling Cavities

Proposal and design of 81.25 MHz heavy ion drift tube linacs for BISOL

Design, fabrication, and cold test of an S-band high-gradient accelerating structure for compact proton therapy facility

Fabrication and cold test of prototype of spatially periodic radio frequency quadrupole focusing linac

Development of the Lanzhou Heavy Ion Linac

Miniaturized P-Band MW-Level Klystron With CeSRRs for CSNS Linac Application

Multi-physics Analysis and Experiment of a CW Four-Rod RFQ

An X-band Disk-and-washer Accelerating Structure for Electron Accelerators

A Compact X-Band Linac for an X-Ray FEL