Coherent effects in microwave backscattering models for forest canopies
S.S. Saatchi,K.C. McDonald
DOI: https://doi.org/10.1109/36.602545
IF: 8.2
1997-07-01
IEEE Transactions on Geoscience and Remote Sensing
Abstract:In modeling forest canopies, several scattering mechanisms are taken into account, (1) volume scattering; (2) surface-volume interaction; (3) surface scattering from forest floor. Depending on the structural and dielectric characteristics of forest canopies, the relative contribution of each mechanism in the total backscatter signal of an imaging radar can vary. In this paper, two commonly used first-order discrete scattering models, distorted Born approximation (DBA) and radiative transfer (RT) are used to simulate the backscattered power received by polarimetric radars at P-, L-, and C-bands over coniferous and deciduous forests. The difference between the two models resides on the coherent effect in the surface-volume interaction terms. To demonstrate this point, the models are first compared based on their underlying theoretical assumptions and then according to simulation results over coniferous and deciduous forests. It is shown that by using the same scattering functions for various components of trees (i.e. leaf, branch, stem), the radiative transfer and distorted Born models are equivalent, except in low frequencies, where surface-volume interaction terms may become important, and the coherent contribution may be significant. In this case, the difference between the two models can reach up to 3 dB in both co-polarized and cross-polarized channels, which can influence the performance of retrieval algorithms.
imaging science & photographic technology,remote sensing,engineering, electrical & electronic,geochemistry & geophysics