Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

Bayesian Estimation of Soil-Water Characteristic Curves

Influences Affecting the Soil-Water Characteristic Curve

Bayesian Analysis of Soil-Water Characteristic Curve Using Markov Chain Monte Carlo Simulation and Its Application on Soil Water Infiltration

Computation of one-dimensional consolidation of unsaturated soil with linear soil-water characteristic curve

Prediction of Soil-Water Characteristic Curve for Unbound Material Using Fredlund–Xing Equation-Based ANN Approach

Probabilistic Analysis of Soil-Water Characteristic Curve with Bayesian Approach and Its Application on Slope Stability under Rainfall Via A Difference Equations Approach

Prediction of Soil Water Retention Curve Using Bayesian Updating from Limited Measurement Data

Bayesian Inference of Spatially Varying Parameters in Soil Constitutive Models by Using Deformation Observation Data

Bayesian reliability-based prediction of the soil water retention curve using finite data

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

A method for estimating soil-water characteristic curve from grain-size distribution

Prediction of Soil-Water Characteristic Curve Using Artificial Neural Network Approach

Back-Calculated Soil–Water Characteristic Curve from Fluid Flow Data

A novel equation for simulating the bimodal soil–water retention curve of unsaturated soils

Uncertainty of the Soil–Water Characteristic Curve and Its Effects on Slope Seepage and Stability Analysis under Conditions of Rainfall Using the Markov Chain Monte Carlo Method

Efficient Bayesian Inverse Modeling of Water Infiltration in Layered Soils

Prediction of the soil-water characteristic curve based on the specific surface area of fine-grained soils

Estimating soil-water characteristic curve based on soil type and best-fitting regressions derived from a simplified method using Aburra Valley dataset

Variability in the measured soil‒water characteristic curve with respect to the numbers of specimens

An improved method for determining Brooks–Corey model parameters from horizontal absorption

A universal soil–water characteristic curve model based on the particle size distribution and fractal theory