Abstract:Energy and mass transfer in photocatalytic systems plays a significant role in photocatalytic water splitting, but relevant research has long been ignored. Here, an interfacial photocatalytic mode for photocatalytic hydrogen production is exploited to optimize the energy and mass flows and mainly includes a heat-insulating layer, a water-channel layer, and a photothermal photocatalytic layer. In this mode, the energy flow is optimized for efficient spreading, conversion, and utilization. A low-loss path (ultrathin water film) and an efficient heat localized zone are constructed, where light energy, especially infrared-light energy, can transfer to the target functional membrane surface with low loss and the thermal energy converted from light can be localized for further use. Meanwhile, the optimization of the mass flow is achieved by improving the desorption capacity of the products. The generated hydrogen bubbles can rapidly leave from the surface of the photocatalyst, along with the active sites being released timely. Consequently, the photocatalytic hydrogen production rate can be increased up to about 6.6 times that in a conventional photocatalytic mode. From the system design aspect, this work provides an efficient strategy to improve the performance of photocatalytic water splitting by optimizing the energy and mass flows.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.1c01108?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.1c01108</a>.Theoretical calculation and analysis, photos, EDS spectrum, transmission spectrum, other curves of hydrogen evolution, SEM images, XRD patterns, absorption spectra, and curves of temperature changes (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c01108/suppl_file/am1c01108_si_001.pdf">PDF</a>)Video S1. Bubbles growing on the membrane sample submerged in water 10 mm below the surface (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c01108/suppl_file/am1c01108_si_002.mp4">MP4</a>)Video S2. Bubbles growing on the membrane sample submerged in water 5 mm below the surface (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c01108/suppl_file/am1c01108_si_003.mp4">MP4</a>)Video S3. Bubbles growing on the membrane sample submerged in water 2 mm below the surface (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c01108/suppl_file/am1c01108_si_004.mp4">MP4</a>)Video S4. Bubbles growing on the membrane sample but taking only little pressure from water (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c01108/suppl_file/am1c01108_si_005.mp4">MP4</a>)Video S5. Hydrogen bubbles sticking on the photocatalytic membrane when the photocatalytic reaction is being carried out (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c01108/suppl_file/am1c01108_si_006.mp4">MP4</a>)This article has not yet been cited by other publications.

Enhanced photocatalytic hydrogen peroxide production at a solid-liquid-air interface via microenvironment engineering

Enhanced H2O2 Utilization Efficiency in Fenton-like System for Degradation of Emerging Contaminants: Oxygen Vacancy-Mediated Activation of O2.

Bubble-water/catalyst triphase interface microenvironment accelerates photocatalytic OER via optimizing semi-hydrophobic OH radical

Synergistic effect of triphase interface and fluid control for efficient photosynthesis of residue-free H2O2

Photocatalytic H2O2 Generation Reaction with A Benchmark Rate at Air‐Liquid‐Solid Joint Interfaces

Highly Efficient Photocatalytic H2O2 Production in Microdroplets: Accelerated Charge Separation and Transfer at Interfaces

Enhancing Photosynthesis Efficiency of Hydrogen Peroxide by Modulating Side Chains to Facilitate Water Oxidation at Low-Energy Barrier Sites

Small-molecule catalyzed H2O2 production via a phase-transfer photocatalytic process

Highly Efficient Photocatalytic H2O2 Production in Microdroplets: Accelerated Charges Separation and Transfer at Interface

Water quality constraints H2O2 production in a dual-fiber photocatalytic reactor

Liquid–Liquid–Solid Triphase Interface Microenvironment Mediates Efficient Photocatalysis

Hydrophobic covalent organic frameworks utilized Fluorocarbon/Water system for efficient hydrogen peroxide photosynthesis

Interfacial Design to Enhance Photocatalytic Hydrogen Evolution via Optimizing Energy and Mass Flows

An in-depth study of integrating cascaded photocatalytic H2O2 generation and activation with solar-driven interfacial evaporation for in-situ organic contaminant remediation

Photocatalytic H<sub>2</sub>O<sub>2</sub> production Systems: Design strategies and environmental applications

Microdroplet assisted hollow ZnCdS@PDA nanocages' synergistic confinement effect for promoting photocatalytic H2O2 production.

Perfluoroalkyl-modified covalent organic frameworks for continuous photocatalytic hydrogen peroxide synthesis and extraction in a biphasic fluid system

Engineering a concordant microenvironment with air-liquid-solid interface to promote electrochemical H2O2 generation and wastewater purification

Direct Z-scheme WO3/Covalent organic frameworks (COFs) heterostructure for enhanced photocatalytic hydrogen peroxide production in water

Floatable Photocatalyst to Synergistically Promote CO2 Reduction and Water Oxidation by Creating Oriented Charge Separation across Tri-phase Interface

Highly efficient photosynthesis of hydrogen peroxide in ambient conditions