Abstract:With the increasing demand for the resilient capacity of transformers in high-proportion renewable energy grids, the overload capacity of transformers and the thermal conductivity of winding insulation materials have been put forward as important requirements. In response to these requirements, a novel ceramic high temperature tolerance insulation winding is proposed in this paper and is applied in a ceramic insulated winding transformer. A combination of simulation and experimentation is used to analyze the thermal-flow characteristics of this transformer. The temperature and flow field distribution characteristics of transformers with both winding insulation methods (ceramic and Nomex paper) are compared. The internal mechanism of reflux near the iron core and high voltage winding under forced air cooling is clarified. A superior outside cooling condition is obtained. A prototype ceramic insulated winding transformer is developed and tested to verify the accuracy of the simulation model. The results show that the hotspot temperature of the ceramic insulated winding transformer under natural cooling is 10.7% lower than that of the Nomex paper insulated winding transformer. With forced air cooling of 2, 3, 4, 5, and 6 m/s applied at the bottom, the hotspot temperature of the ceramic insulated winding transformer is 11.4%, 10.5%, 9.7%, 14.0%, and 17.8% lower than that of the Nomex paper insulation winding transformer, respectively. Under forced air cooling, a reflux phenomenon is observed in both transformers in the vicinity of the iron core and high voltage winding due to the formation of adverse pressure gradient region and wall viscous force blocking. The strength of the reflux is affected by the magnitude of the forced air cooling flow velocity and the construction of the transformer. The optimal range of the external cooling flow velocity for the ceramic insulated winding transformer is 3–4 m/s. The errors between the simulated temperature and the measured temperature at the nine monitoring points of the prototype are all less than 5%, which verifies the effectiveness of the simulation model. The experimental and theoretical basis for the design and application of resilient capacity dry type transformers is provided by this research.

Stress Distribution Characteristics of Composite Wire-Paper Winding Structure under the Radial Electromagnetic Force

Analytical investigation of open-circuit eddy current loss in windings of PM machines

Simplified Analytical Model and Investigation of Open-Circuit AC Winding Loss of Permanent-Magnet Machines.

Numerical Investigations for Vibration and Deformation of Power Transformer Windings under Short-Circuit Condition

Study on the dynamic mechanical properties of winding‐block axial structure considering short circuit strain rate effect

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Inter-Turn Breakdown Fault Analysis and Winding Structure Optimisation of Winding of Dry-Type Transformers in Wind Farms

The occurrence and mechanism of hysteresis between axial deformation and short‐circuit electromagnetic force during the vibration of power transformer windings

Transformer Winding Fault Detection by Vibration Analysis Methods

Strongly Coupled Circuit‐Magnetic‐Structural Effect on Winding Vibration Process of Power Transformer

Comparative analysis of the characteristics of outlet short circuit and winding insulation fault of distribution transformer and its preventive measures

Distributed Vibration Monitoring System for 10 kV-400 kVA 3D Wound Core Transformer under Progressive Short-Circuit Impulses

Quantitative Research on Accumulative Effect of Transformer Winding Deformation and Its Influence Degree Based on Time-Frequency Analysis of Vibration Signal

Study on the Stress Distribution Characteristics of Dry- Type Bushing under Different Loads

Modeling and Evaluation of Winding Losses in High Voltage Planar Transformers

Experimental Research on Power Transformer Vibration Distribution under Different Winding Defect Conditions

A Study Of The Transient Vibration Of Transformer Windings

Winding vibration analysis of unbalanced transformer based on electromagnetic-mechanical coupling

Electromagnetic-thermal-structure multi-layer nonlinear elastoplastic modelling study on epoxy-impregnated REBCO pancake coils in high-field magnets

Thermal-flow characteristics analysis of a novel resilient capacity ceramic insulated winding dry type transformer

Investigating the effect of transverse compressive loads on the electromagnetic performance of superconducting CORC® cables