Abstract:Loop heat pipe (LHP) is widely used to solve the problem of high heat flux in electronic chips due to its excellent heat transfer efficiency, good thermal equilibrium, and large heat transfer limit. To further improve the heat transfer efficiency of the LHP, a novel LHP was designed with a parallel arrangement of 13 vapor channels (2 mm × 2 mm) capillary wick structure. Experimental investigations were conducted to evaluate the start-up and steady-state performance of the LHP under both regular and random variable loads ranging from 30 W to 180 W. The findings indicate that the LHP exhibits rapid start-up and operates smoothly within the heat load range of 30 W–180 W, maintaining the heat source temperature below 75 °C, thereby meeting the temperature requirements for chip operation.Under a regular variable heat load, the LHP experiences minimal temperature fluctuations, but the system operated with good stability. Meanwhile, under random variable heat loads, the LHP demonstrates quick responsiveness within 5 s and reaches a stable state within 8 min. The temperature fluctuations remain within 2 °C, effectively fulfilling the temperature control demands of electronic devices. Furthermore, the evaporator thermal resistance, condenser thermal resistance, loop thermal resistance and system thermal resistance of the LHP gradually decrease with increasing of heat load. When reaching a heat load of 180 W, the evaporator thermal resistance (Re ), condenser thermal resistance (Rc ), loop thermal resistance (RLHP ), and system thermal resistance (Rsys ) reach their minimum, with values of 0.0168 °C/W, 0.121 °C/W,0.137 °C/W and 0.229 °C/W, respectively. In comparison with other LHPs, the evaporator temperature was only 59.56 °C with the highest heat load of 210 W (52.5 W/cm2), which expanded the application range of the LHP for electronic devices cooling.

Design, Fabrication, Investigation and Analysis of a Novel Flat Evaporator Loop Heat Pipe for Cooling High Heat Flux Server Chips

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental study on the thermal performance of a liquid-cooled heat sink integrating heat pipes for dual CPU servers

Experimental investigation on the thermal performance of a novel loop heat pipe (LHP) with micro-channel structure

Directly Air-Cooled Compact Looped Heat Pipe Module for High Power Servers with Extremely Low Power Usage Effectiveness

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Experimental research on the thermal performance of a flat evaporator loop heat pipe with a new composite wick

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling

Experimental study on a rectangular evaporator loop heat pipe with a phase-change material heat sink

Experimental studies on a high performance compact loop heat pipe with a square flat evaporator

A Dumbbell-Shaped 3D Flat Plate Pulsating Heat Pipe Module Augmented by Capillarity Gradient for High-Power Server CPU Onsite Cooling

Experimental Investigation Thermal Performance of Loop Heat Pipe Operating with Different Working Fluids

Experimental investigation on the start-up performance of a novel flat loop heat pipe with dual evaporators

Study of a new thin flat loop heat pipe for electronics

Thermal Characteristics of a Flat Plate Pulsating Heat Pipe Module for Onsite Cooling of High Power Server CPUs

Experimental investigation of a loop heat pipe with a flat evaporator and cupric oxide nanofluids as working fluid

Experimental study on a novel loop heat pipe with both flat evaporator and boiling pool

Experimental investigation for the loop heat pipe with a bifacial flat evaporator

Advanced loop heat pipe application for cooling high power LED lights

Effect of the working fluid transportation in the copper composite wick on the evaporation efficiency of a flat loop heat pipe