Abstract:To challenge the continuous operation performance of high energy density lithium-ion batteries at different ambient temperatures. A battery thermal management system combining Multi-stage tesla valve liquid cooling and Phase change material (MP) is proposed. After verification of the accuracy of the thermal model based on experimental measurements, numerical studies are performed at the end of 2C rate discharge. In addition, based on general full factorial design method, Kriging approximation model is used to construct complex nonlinear hybrid model between the spacing between batteries, the number of MSTV channels, coolant velocity and the performance of MP (pressure drop, standard deviation of surface temperature, and maximum temperature). At the same time, to avoid falling into local solutions, the adaptive simulated annealing (ASA) global search algorithm is integrated to optimize high-dimensionality multi-objective structural settings. The simulation results show that the designed MP-BTMS is connected with water/ethanol coolant and the inlet velocity is 0.193 m/s, the maximum temperature, standard deviation of surface temperature and pressure drop of the battery pack at 33.12 °C, 1.50 °C and 647.8 Pa, respectively. Finally, the optimised MP is used in continuous depth discharge conditions, as well as a range of simulation tests. The superiority of the optimum battery thermal management system in different application scenarios (liquid cooling/heating) is also verified. The cooling performance indicates that the use of MP reduces the total energy consumption required for coolant circulation by 79.9% compared to conventional BTMS. Moreover, it is found that at ambient temperature ( Tamb =-10 °C), the use of MP can keep the battery module warm twice as long compared to conventional BTMS. This means that MP can significantly delay the temperature drop during cold stops of EVs, thus reducing the energy required for active battery heating after short-term parking.

Battery Thermal Management Strategy for Electric Vehicles Based on Nonlinear Model Predictive Control

A Thermal Management Strategy for Proton Exchange Membrane Fuel Cell via Nonlinear Model Predictive Control

A thermal management method for lithium-ion battery based on fuzzy model predictive control

An Intelligent Thermal Management System for Optimized Lithium-Ion Battery Pack

Air and PCM cooling for battery thermal management considering battery cycle life

A Precise Temperature Control Method for Lithium-ion Battery Pack based on the Nonlinear Model Predictive Control Algorithm

An MPC-Based Control Strategy for Electric Vehicle Battery Cooling Considering Energy Saving and Battery Lifespan

Modeling and Model Predictive Control of a Battery Thermal Management System Based on Thermoelectric Cooling for Electric Vehicles

Optimization of Battery Charging Strategy Based on Nonlinear Model Predictive Control

Hierarchical optimal intelligent battery thermal management strategy for an electric vehicle based on ant colony sliding mode control

Research on control strategy of electric vehicle battery thermal management system based on MPC

Machine Learning Assisted Multi-Objective Design Optimization for Battery Thermal Management System

A Two-Stage Real-Time Optimized EV Battery Cooling Control Based on Hierarchical and Iterative Dynamic Programming and MPC

A Fast Thermal Simulation and Dynamic Feedback Control Framework for Lithium-Ion Batteries

Integrated Thermal Management of Electric Vehicles Based on Model Predictive Control With Approximated Value Function

Two-level optimization strategy for vehicle speed and battery thermal management in connected and automated EVs

Energy-efficient operation of the thermal management system in electric vehicles via integrated model predictive control

Supervised-Learning-Based Optimal Thermal Management in an Electric Vehicle

A novel control strategy for active battery thermal management systems based on dynamic programming and a genetic algorithm

Novel concept design of low energy hybrid battery thermal management system using PCM and multistage Tesla valve liquid cooling

Integrated Optimal Fast Charging and Active Thermal Management of Lithium-Ion Batteries in Extreme Ambient Temperatures