Abstract:This paper investigates the frictional receding contact problem between a functionally graded (FG) layer resting on a homogeneous coated half-plane when the system indented by a rigid cylindrical punch. The shear modulus of the upper graded layer is assumed to vary exponentially in the depth direction. Upon loading, the advancing contact and receding contact occur between the FG layer and rigid punch and between the FG layer and coating, respectively. Under the assumptions of sliding contact, the shear and normal contact stresses are related through Coulomb's law of friction. The contact problem is converted analytically using Fourier integral transforms and the proper boundary conditions into a system of two singular integral equations. The unknowns of these integral equations consist of the contact stresses under the punch and between the FG layer and coating as well as the dimensions of the contact zones. The Gauss–Jacobi quadrature collocation method is then employed to transform the singular integral equations into a system of nonlinear equations which are solved using an appropriate iterative algorithm to compute the contact stresses and the dimensions of the contact areas. The main purpose of this paper is to examine the influence of several parameters on the upper and lower contact stresses, which include the material inhomogeneity parameter, friction coefficient, punch radius, applied load, thickness of homogeneous layer, shear modulus of homogeneous layer and shear modulus of homogeneous half-plane. One of the most important conclusions from this study is that the contact stresses and contact areas can be controlled with the addition of the homogeneous layer.

The Dynamic Contact of a Viscoelastic Coated Half-Plane under a Rigid Flat Punch

DYNAMIC RESPONSE OF VISCOELASTIC HALF-SPACE UNDER MOVING LOADS

Analysis of stress and deformation of an exponentially graded viscoelastic coated half plane under indentation by a rigid flat punch indenter tip

Electro-mechanical frictionless contact behavior of a functionally graded piezoelectric layered half-plane under a rigid punch

Axisymmetric thermoelastic contact of an FGM-coated half-space under a rotating punch

Contact problem of two punches in an elastic coating attached to a porous material

Time harmonic point load and dynamic contact problem of contacting fluid and poroelastic half-spaces

On piezoelastic contact problem for a smooth punch

Two-dimensional contact problem for a coating–graded layer–substrate structure under a rigid cylindrical punch

The Use Of Flat Punch Indentation To Determine The Viscoelastic Properties In The Time And Frequency Domains Of A Soft Layer Bonded To A Rigid Substrate

The Axisymmetric Torsional Contact Problem of a Functionally Graded Piezoelectric Coated Half-Space

Fundamental Solutions to Contact Problems of a Magneto-Electro-elastic Half-Space Indented by a Semi-Infinite Punch

Size-dependent axisymmetric contact vibration analysis with couple stress

The dynamic response of the FGM coated half-plane with hysteretic damping under time harmonic loading

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

DYNAMICS AND CONTROL OF NON-LINEAR CIRCULAR PLATES WITH PIEZOELECTRIC ACTUATORS

A novel cylindrical punch method to characterize interfacial adhesion and residual stress of a thin polymer film

The Elasto-Electric Field for a Rigid Conical Punch on a Transversely Isotropic Piezoelectric Half-Space

Frictional receding contact problem of a functionally graded layer resting on a homogeneous coated half-plane

Dynamic indentation of viscoelastic orthotropic layer supported by a Winkler–Pasternak foundation

3-D Model of the Periodic Structure Punch Sliding upon the Viscoelastic Base with Incompressible Fluid in the Contact Gap