Accumulation and source apportionment of heavy metal(loid)s in agricultural soils based on GIS, SOM and PMF: A case study in superposition areas of geochemical anomalies and zinc smelting, Southwest China
Xuexian Li,Hongyan Liu,Wei Meng,Nanting Liu,Pan Wu
DOI: https://doi.org/10.1016/j.psep.2022.01.072
IF: 7.8
2022-03-01
Process Safety and Environmental Protection
Abstract:Heavy metal(loid)s (HMs) in soils of Southwest China naturally have a high background and are superimposed with intensive anthropogenic activities, resulting in serious accumulation of HMs in regional agricultural soils, which poses threat to ecological security and agricultural product quality. The accumulation and source apportionment of HMs in agricultural soils are not only one of the focuses of global concern but also a challenging task worldwide. In the present study, a total of 395 topsoil samples (0–20 cm) and 19 deep soil samples (150–180 cm) were collected from typical artisanal zinc smelting regions in northwestern Guizhou Province, China to investigate the spatial distribution, accumulation and source apportionment of HMs (As, Cr, Cu, Hg, Ni, Pb, Cd and Zn) based on the combined approach of enrichment factor (EF), self-organizing map (SOM), geographical information system (GIS), and positive matrix factorization (PMF). The mean contents of As, Cr, Cu, Hg, Ni, Pb, Cd and Zn in agricultural soils all exceeded the corresponding local background values, and obvious enrichment of Cd was found in the studied topsoil, followed by Pb, Cu, and Zn. Combined with SOM and PMF analysis, five potential HMs sources were identified: Cd (74.58%), As (32.05%), Zn (30.57%), Hg (23.16%), and Pb (11.38%) were associated with artisanal Zn smelting activities; Cu (66.08%), Zn (18.12%), Ni (17.25%), Cd (16.95%), and Pb (10.08%) were mainly from agricultural activities; Pb (68.9%), Zn (25.73%), and As (22.64%) were mainly from traffic emissions and smelting-related activity sources; Hg (68.55%), As (45.31%), Cr (38.63%), and Ni (32.44%) were primarily from atmospheric deposition associated with industrial activities and coal combustion; and Cr (61.01%), Ni (44.52%), Zn (17.32%), Cu (16.11%), and Cd (8.39%) mainly originated from soil parent materials. The proportions of the five potential sources were 14.5%, 20.9%, 19.8%, 17.8%, and 27%, respectively. Anthropogenic sources accounted for the largest contribution (approximately 73%) to the soil HMs, especially the artisanal zinc smelting activities to Cd, Zn, As, Hg, and Pb, which was significantly higher than that of geological sources, suggesting that intense human activities produced a large amount of HMs enrichment in topsoil. The SOM clustering and source apportionment of soil HMs are of great significance for reducing HMs pollution sources, and can provide scientific guidance for pollution prevention and regional remediation of HMs in agricultural soils.Download : Download high-res image (218KB)Download : Download full-size imageMetal (loids) and Rare Earth Elements (REE) ('metals') are used in a wide range of products, and therefore, the improvement of expectations for everyday comforts with demand continues to grow. Metal-bearing wastes are a secondary source of raw material that can meet this demand by providing a previously unconsidered low impact supply source. Total annual leachate production is 1,056,716 m3. Therefore, landfill leachate emerges as a significant potential resource as it contains high concentrations of metals. However, realising a profitable return on investment for leachate processing is a challenge due to relatively low recovery rates of approximately 0.02% of total heavy metals in a landfill being leached out in 30 years. Variation within the multi-element value and the effect of other chemicals in these complex mixtures. There is a need to better understand the mechanisms and potential applicability of extraction methods for optimising metals recovery from leachate. This paper addresses this need by providing a systematic review of the critical factors and environmental conditions that influence the behaviour of metals within the landfilled waste. The paper provides a synthesis of how the factors and conditions may affect leachate recirculation efficiency for recovery in the context of a range of opportunities and challenges facing circular economy practitioners. To approach feasibility metal recovery economically from landfill leachate without energy-intensive and environmentally destructive, future research actions need to be initiated in lab-based and later on semi-pilot to pilot studies, which the review can help achieve the challenges.Technology critical elements (TCE) are considered the vitamins of nowadays technology. Factors such as high demand, limited sources and geopolitical pressures, mining exploitation and its negative impact, point these elements as new emerging contaminan -Abstract Truncated-
engineering, environmental, chemical