Single‐pole Fault Protection for MMC‐HVDC Transmission Line Based on Improved Transient‐extracting Transform

Yiqing Liu,Hao Guo,Guangbin Zhu,Gang Yu
DOI: https://doi.org/10.1002/2050-7038.13254
IF: 2.639
2021-01-01
International Transactions on Electrical Energy Systems
Abstract:Due to the overload limitation of the converters, the main protection for DC lines of High Voltage Direct Current based on Modular Multilevel Converter (MMC-HVDC) requires ultra high speed for fault detection. The protection principles of single-terminal traveling-wave can meet this requirement. Such protection principles which are usually constructed by transmission theory of fault traveling-wave have a clear physical concept and do not depend on boundary components. Almost all of these principles are dependent on accurately detecting the arrival time of the traveling-waves. Thus, it is urgent to research a new time-frequency analysis method with a high time resolution to identify the arrival time of traveling-wave. This paper introduces Transient-Extracting Transform (TET) to detect traveling-wave and improves it fully considering the fault traveling-wave characteristics of DC lines. The time resolution of improved TET is greatly increased and the arrival time of traveling-wave is detected more accurately. Using the improved TET, a protection scheme for single-pole fault based on the arrival time difference between aerial-mode traveling-wave and zero-mode traveling-wave is studied. The theoretical analysis and simulation results show that the performance of detecting traveling-wave arrival time by the improved TET is higher than wavelet transform. Under the same fault condition, the time resolution of wavelet transform is only tens microsecond level. However, the time resolution of the improved TET increases to several microseconds. The accuracy of traveling-wave detection by the improved TET is 95% higher than existing works. The simulation results also indicate that the single-pole protection scheme using the improved TET can accurately distinguish between internal faults and external faults. There is a better ability to resist fault resistance for the protection scheme, and it is not affected by DC boundary elements.
What problem does this paper attempt to address?