Abstract:The performance of grouting materials directly affects the reinforcement effect of fractured rock masses by grouting. This paper investigates the synergistic effect of graphene oxide and fly ash on the properties of cementitious grout materials and the cementing effect of grouting reinforcement on broken rock masses. Basic performance tests such as flowability, bleeding rate, and setting time of grout slurries were conducted, and macroscopic characterization were tested for flexural strength, compressive strength, permeability and resistivity of the hardened grout paste. Direct shear tests of slurry-rock interfaces were performed using a self-made shear box, and the microstructures and mineral compositions of the slurry-rock interfaces were analyzed by scanning electron microscopy (SEM) and X-ray diffraction (XRD). The test results show that the flowability, bleeding rate, and initial setting time of graphene oxide and fly ash (GO-FA) cement-based grout slurries with a water-cement ratio of 0.8 are 413 mm, 4.8 %, and 12.7 h, respectively, indicating high flowability and stability. The 28-day flexural strength, compressive strength, and permeability of GO-FA the hardened grout paste are 4.6 MPa, 25.7 MPa, and 1.50 × 10 −9 cm/s, respectively, which are 28.5 %, 30.4 %, and 25.4 % higher than those of pure cement hardened grout paste. The electrical resistivity of the hardened grout pastes increases with the curing time of the slurry and eventually stabilizes, and a linear relationship between compressive strength and electrical resistivity is established. The reinforcement effect of GO-FA grout filling on broken rock masses is the best, with significantly increased peak shear strength and residual strength of the slurry-rock interface after grouting compared to traditional cement grout filling, indicating enhanced deformation resistance and a 19.8 % increase in cohesion. Grouting filling significantly improves the cohesion and internal friction angle of fractured rock mass interfaces, with the cohesion and internal friction angle of the slurry-rock interface after grouting filling with a thickness of 1 mm being 3.90 times and 1.28 times higher, respectively, than those of the unfilled fractured surface. The filling thickness has a significant effect on cohesion but little effect on the internal friction angle. The microstructure model of the slurry-rock interface is consistent with the Xie model, indicating the generation of hydration products such as calcium hydroxide and ettringite on the interface, as well as small amounts of potassium feldspar, kaolinite, and the new mineral component calcite.

Shear Properties of Grout-Rock Interface for Treatment of Mud Inrush

Experimental study of the direct shear characteristics of cement grout under constant normal loading and stiffness boundary conditions

Sedimentation-affected Engineering Performances and Microstructures of a Hybrid Portland- Sulfate Aluminate Cement Grout Cast in Long Tubes

Experimental study on the shear behavior of grout-infilled specimens and micromechanical properties of grout-rock interface

Study of grouting effectiveness based on shear strength evaluation with experimental and numerical approaches

Unraveling the shear behaviors of bonding interface for post-grouted sandstones considering the temperature and confining pressure effects

Experimental investigation on the failure mechanism of grouted rock mass: Mesostructure and macroscopic mechanical behavior

Study on the properties of graphene oxide cementitious grout materials and its cementing effect in reinforcing broken rock mass by grouting

Experimental study on the effect of grouting reinforcement on the shear strength of a fractured rock mass

Grouting effect on rock fracture using shear and seepage assessment

Rheological Characteristics of Cement Grout and its Effect on Mechanical Properties of a Rock Fracture

Advanced Grouting Model and Influencing Factors Analysis of Tunnels with High Stress and Broken Surrounding Rock

In-situ direct shear test and numerical comparative research on mudstone gravel slope reinforced by polymer grouting

Strength Laws and Crack Evolution Mechanism of Slurry Grouting under High-Permeability and High-Stress Curing Conditions

Investigations on Shear Properties of Soft Rock Joints under Grouting

Investigation and practical application of a new cementitious anti-washout grouting material

Experimental study and engineering application of anti-washout properties of underwater karst grout

Experimental Study on Performance of Modified Cement-Based Building Materials under High-Water-Pressure Surrounding Rock Environment

Penetration mechanism of grouting by using the cement-based slurry with time-dependent viscosity

Exploring on Grouting Reinforcement Mechanism of Expansive Slurry

Experimental research on mechanical performance of grouting plugging material with large amount of fly ash