Abstract:The quadrature angular diversity aperture (QADA) receiver, consisting of a quadrant photodiode (QPD) and an aperture placed above the QPD, has been investigated for pose estimation for visible light systems. Current work on pose estimation for the QADA receiver uses classical camera sensor algorithms well known in computer vision. To this end, however, the light spot center first has to be obtained based on the RSS. However, this is less straightforward than for camera sensors, as in contrast to such sensors where the relationships are linear, the RSS output from the QADA is a non-linear function of the light spot position. When applying closed form solutions or iterative methods for cameras on a QADA, the non-linearity will degrade their performance. Furthermore, since in practice the aperture is not always perfectly aligned with the QPD, a procedure to calibrate the receiver is needed. Current work on calibration requires additional sophisticated equipment to measure the pose during calibration, which increases the difficulty of implementation. In this paper, we target the above problems for pose estimation and calibration of the QADA receiver. To this end, we first study the effect of the strategy of differencing and normalization on the probability density function (PDF), a commonly applied strategy for the QPD's robustness against RSS variation, and it is shown that the applied strategy results in a complex PDF, which makes an effective and efficient estimation hard to achieve. Therefore, we derive an approximated PDF in a simple closed-form, based on which the calibration and the pose estimation algorithms using the least squares principle are proposed. The proposed calibration does not require any information about the pose of the receiver and is robust to variation of the received power and imperfect knowledge of the radiation pattern of the LED, making it easy to implement. We also derive the corresponding Cramér-Rao lower bound on the misalignment to benchmark the performance of the misalignment and to serve as an indicator to determine the required signal-to-noise ratio (SNR) or number of LEDs to obtain a desired accuracy. The calibration and pose estimation are evaluated by means of a Monte Carlo simulation. Computer simulations show that this theoretical bound is close to the RMSE of the proposed estimator and that the proposed pose estimator outperforms the PnP algorithm.

Theoretical Bound of Position and Orientation Estimation for Visible Light Systems Subject to NLOS Channel and Power Uncertainty

Performance Limits of Visible Light-Based User Position and Orientation Estimation Using Received Signal Strength under NLOS Propagation

Joint User Location and Orientation Estimation for Visible Light Communication Systems with Unknown Power Emission

MLE-based Localization and Performance Analysis in Probabilistic LOS/NLOS Environment

Visible Light Communication-Enabled Simultaneous Position and Orientation Detection for Harnessing Multipath Interference and Random Fading

Localization Algorithm Design and Performance Analysis in Probabilistic LOS/NLOS Environment.

On the Fundamental Performance Limit Of Visible Light-Based Positioning

Performance Limits of Visible Light-Based Positioning for Internet-of-Vehicles: Time-Domain Localization Cooperation Gain

Visible Light-Based User Position, Orientation and Channel Estimation Using Self-Adaptive Location-Domain Grid Sampling

Robust Visible Light-Based Simultaneous Position and Orientation Estimation Without Radiation Pattern Assumption

Visible Light Positioning under Luminous Flux Degradation of LEDs

Cone Geometry-Based Simultaneous 3D Position and Orientation Estimation for Visible Light Systems

Indoor Visible Light Positioning Based on Channel Estimation and Cramér–Rao Low Bound Analysis with Random Receiving Orientation of User Equipment

Visible Light Positioning with Intelligent Reflecting Surfaces under Mismatched Orientations

Optimal Resource Management for NOMA-Based Visible Light Communication Systems with Shot Noise

Performance Limits of Passive Visible Light Positioning Using Shadowing Effects

Pose Estimation for Visible Light Systems Using a Quadrature Angular Diversity Aperture Receiver

Design and Performance Analysis for Indoor Visible Light Positioning With Single LED and Single-Tilted-Rotatable PD

Optimal Power Allocation for Integrated Visible Light Positioning and Communication System With a Single LED-Lamp

Accuracy analysis of indoor visible light communication localization system based on received signal strength in non-line-of-sight environments by using least squares method

6-Dof Location-and-Pose Estimation Towards Integrated Visible Light Communication and Sensing: Algorithm Design and Performance Limits