Abstract:The sole micropores strictly restrict the wide utilization of TS-1 zeolite in the catalytic fields, especially in the catalytic conversion of compounds with large molecular sizes. Here, we report a feasible and economical method to overcome this drawback. In this work, the hierarchical TS-1 zeolite was constructed via post-acid treatment, post-alkali etching, and a combination of post-acid treatment and alkali etching methods, after which, the corresponding NiMo-supported catalysts were prepared via the incipient wetness impregnation method. Then, the aforementioned materials were fully characterized using X-ray diffraction (XRD), N-2 adsorption-desorption, pyridine adsorbed Fourier transform infrared spectroscopy (Py - FTIR), H-2 temperature programmed reduction (H-2 - TPR), X-ray photoelectron spectroscopy (XPS), and high-resolution transition electron microscope (HR-TEM) to unravel the changes in the physicochemical properties caused by the post treatments. Finally, the hydrodesulfurization of dibenzothiophene (DBT) was used as a probe to assess the effects of the post-treatments on the catalytic performance of the hierarchical NiMo/TS-1 catalysts. The results showed that the MFI topology of TS-1 zeolite remained undamaged significantly and the serial hierarchical TS-1 zeolites exhibited higher specific surface areas and mesopore structures. Moreover, appropriate amounts of Bronsted acid sites were formed at the surface of the serial hierarchical TS-1 zeolites. The interaction between the active metals and the support materials was also modulated by the post-treatment of TS-1 zeolite, which resulted in better dispersion of Ni promoted MoS2 slabs with a higher proportion of NiMoS active phase, further leading to the enhanced catalytic activity and direct desulfurization pathway selectivity of the corresponding serial hierarchical NiMo/TS-1 catalysts. Among all the prepared catalysts, the catalytic activity was enhanced by approximately 1.2 times over catalyst NiMo/AT-TS-1 obtained by post-acid treatment compared to that over catalyst NiMo/TS-1 without treatment and on which the selectivity of the DDS pathway was 22% higher compared to that over catalyst NiMo/TS-1.

Preparation and Catalytic Performance in Propylene Epoxidation of Hydrophobic Hierarchical Porous TS-1 Zeolite

Epoxidation of Propylene with Dilute H 2 O 2 over Titanium Silicalite Containing Trace Aluminum

Hierarchical TS-1 zeolite loaded with NiMo catalysts: Preparation and performance in hydrodesulfurization

Enhanced Catalytic Oxidation by Hierarchically Structured TS-1 Zeolite

Au/TS-1 catalyst for propylene epoxidation with H2 and O2: Effect of surface property and morphology of TS-1 zeolite

Tailoring Porosity and Titanium Species of TS-1 Zeolites via Organic Base-assisted Sequential Post-treatment

Insight into the Effect of Mass Transfer Channels and Intrinsic Reactivity in Titanium Silicalite Catalyst for One-Step Epoxidation of Propylene

Hierarchical Titanium Silicalite-1 Zeolites Featuring an Ordered Macro–Meso–Microporosity for Efficient Epoxidations

Direct Synthesis of Hierarchically Porous TS‐1 Through a Solvent‐evaporation Route and Its Application As an Oxidation Catalyst

Synthesis of Hydrophobic Nanosized Hierarchical Titanosilicate-1 Zeolites by an Alkali-Etching Protocol and Their Enhanced Performance in Catalytic Oxidative Desulphurization of Fuels

The High‐Performance Hollow Silicalite‐1@Titanium Silicalite‐1 Core‐Shell Catalyst for Propene Epoxidation

Synthesis of Low Cost Titanium Silicalite-1 Zeolite for Highly Efficient Propylene Epoxidation

Preparation of hierarchical TS-1 molecular sieve membrane catalyst and its catalytic performance for chloropropylene epoxidation

Synthesis of Ti-Containing Silica Mesoporous Molecular Sieves with High Catalytic Activity for Epoxidation

Hydrothermal Modification of TS-1 Zeolites with Organic Amines and Salts to Construct Highly Selective Catalysts for Cyclopentene Epoxidation

Synthesis of titanium silicalite (TS-1) from the TPABr system and its catalytic properties for epoxidation of propylene

Mechanistic Insight into Propylene Epoxidation with H2O2 over Titanium Silicalite-1: Effects of Zeolite Confinement and Solvent

Review and perspectives on TS-1 catalyzed propylene epoxidation

Catalytic Performance of Amorphous Ti/SiO2 in the Gas‐Phase Epoxidation of Propylene with H2O2

Characterization of Fresh, Deactivated, and Regenerated TS‐1 for Propylene Epoxidation: Investigating Surface Deactivation Species

Optimization of MOFs-induced strategy for preparing anatase-free hierarchical TS-1 towards 1-hexene epoxidation: TPAOH dosage regulation, silanization and stabilizing acidic sites