Abstract:The electromagnetic radiation of electronic equipment carries information and can cause information leakage, which poses a serious threat to the security system; especially the information leakage caused by encryption or other important equipment will have more serious consequences. In the past decade or so, the attack technology and means for the physical layer have developed rapidly. And system designers have no effective method for this situation to eliminate or defend against threats with an absolute level of security. In recent years, device identification has been developed and improved as a physical-level technology to improve the security of integrated circuit (IC)-based multifactor authentication systems. Device identification tasks (including device identification and verification) are accomplished by monitoring and exploiting the characteristics of the IC's unintentional electromagnetic radiation, without requiring any modification and process to hardware devices, thereby providing versatility and adapting existing hardware devices. Device identification based on deep residual networks and radio frequency is a technology applicable to the physical layer, which can improve the security of integrated circuit (IC)-based multifactor authentication systems. Device identification tasks (identification and verification) are accomplished by passively monitoring and utilizing the inherent properties of IC unintended RF transmissions without requiring any modifications to the analysis equipment. After the device performs a series of operations, the device is classified and identified using a deep residual neural network. The gradient descent method is used to adjust the network parameters, the batch training method is used to speed up the parameter tuning speed, the parameter regularization is used to improve the generalization, and finally, the Softmax classifier is used for classification. In the end, 28 chips of 4 models can be accurately identified into 4 categories, then the individual chips in each category can be identified, and finally 28 chips can be accurately identified, and the verification accuracy reached 100%. Therefore, the identification of radio frequency equipment based on deep residual network is very suitable as a countermeasure for implementing the device cloning technology and is expected to be related to various security issues.

Programmable Metasurface Based Microwave Biometric Identification

Machine-learning Reprogrammable Metasurface Imager.

Metamaterials Based Intelligent Microwave Human Behavior Recognition

Intelligent Metasurface Imager and Recognizer

Programmable Metasurface Based Microwave Gesture Detection and Recognition Using Deep Learning

Intelligent Imaging and Sensing based on Programmable Metasurface

Microwave Imaging and Classification of Hand Gestures

Indoor Positioning and Posture Recognition of Human Body Applying Integrating‐Type Intelligent Metasurfaces Based Sensing System

Microwave Reconstruction of 3D Human Facial Landmarks Using a Programmable Metasurface

High‐Resolution Programmable Metasurface Imager Based on Multilayer Perceptron Network

Noncontact Electromagnetic Wireless Recognition for Prosthesis Based on Intelligent Metasurface

High Resolution 3D Microwave Real Time Imaging System Based on Intelligent Metasurface

Intelligent Hand‐Gesture Recognition Based on Programmable Topological Metasurfaces

[Microwave Heartprint: A novel non-contact human identification technology based on cardiac micro-motion detection using ultra wideband bio-radar]

Heart ID: Biometric Identification Using Wearable MIMO RF Heart Sensors

Single-frequency and Single-sensor Three-dimensional Microwave Imaging Using Programmable Metasurface

Electromagnetic Radiation-Based IC Device Identification and Verification Using Deep Learning

MeshID: Few-Shot Finger Gesture Based User Identification Using Orthogonal Signal Interference

Millimeter-Wave Radar-Based Identity Recognition Algorithm Built on Multimodal Fusion

X-MyoNET: Biometric Identification Using Deep Processing of Dynamic Surface Electromyography

Intelligent Electromagnetic Sensing with Learnable Data Acquisition and Processing