Abstract:Accidents of launch vehicles, satellites, and missiles originating from remainder particles account for 6% of the causes in accident investigations. The problem of remainder particles seriously reduces the reliability of sealed electronic components in aerospace. Numerous cases have shown that remainder particles cannot be completely avoided due to process, environment, and other factors. As an important method for detecting remainder particles, the particle impact noise detection (PIND) method has become a standard testing tool in the aerospace field in China. However, there is still a lack of effective and feasible solutions to the problems of sensor sensitivity measurement and consistency evaluation, which are key and indispensable components of the closed-loop process of the PIND method. Through numerous experiments, this article proposed a complete set of new methods and systems for the sensitivity measurement of PIND sensors, allowing real-time measurement of PIND sensor sensitivity at the production site without moving or disassembling the sensor. This article systematically illustrated the feasibility of this new method and system from the perspective of measurement method, measurement system, measurement result verification, and measurement system application. The accuracy and feasibility of the proposed method were verified using the free-field underwater comparison method. The average difference between the two methods was less than 1 dB (1 V/ bar), which meets the practical requirements (±3 dB). In addition, the coupling effect of different coupling agents, the full contact time of coupling agents, and the epoxy adhesive bonding process were further analyzed based on the proposed method and system, and satisfactory improvement results were obtained.

ICA and PIND Based Remainder Particle Detection Technique for Space-borne Equipment

Study of PIND Vibration Detection Conditions for Remainders in Space Relay Based on Curve Fitting Theory

Algorithm Used to Detect Weak Signals Covered by Noise in PIND

The Research of Remainder Particle Auto-detection System for Aerospace Electronic Installation

Analysis method on characteristics of remainders in aerospace electronic equipment based on HHT

A De-noising Algorithm for PIND Signals Based on Kalman Filter

Research and Application of a Novel Sensitivity Measurement Method for Particle Impact Noise Detection Sensors

Research on Auto-detection for Remainder Particles of Aerospace Relay Based on Wavelet Analysis

A feature extraction method for remnant particles based on non-negative tensor factorization in aerospace electronic equipments

Impact Test Condition of Particle Impact Noise Detection for Space Relay Remainders

Research on Particle Impact Noise Auto Detecting System for Sealed Electronic Components

Research on a synchronised classification method for loose particle detection signals of aerospace- sealed electronic components

The Research of Auto-Detection Algorithms For Remainder Particles of Aerospace Relay

Recognition Method of Inherent Mechanical Noise in PIND Signal of Aerospace Relay Based on Pedigree Cluster

Research on Particle Impact Noise Detection Standard

Research on test conditions of sealed-relay remainders based on high-speed video technology

Development of PIND Multichannel Sensor and Research on Redundancy Detection Method

Research on Feature Extraction of Remnant Particles of Aerospace Relays

Feature Extraction of Remnant Material Based on Aerospace Relay Particle Impact Noise Detection Experiment Signal

Material Identification of Particles in Space-Borne Electronic Equipments Based on Principal Component Analysis

Permutation Fuzzy Entropy based ICEEMDAN de-noising for Inertial Sensors