Abstract:The low-pressure atmosphere rich in CO2 (~95%) on Mars makes the in-situ resource utilization of Martian CO2 and the improvement of oxidation attract widespread attention. It contributes to constructing the Mars base which will support the deep space exploration. Conversion of CO2 based on high voltage discharge has the advantages of environmental friendliness, high efficiency and long service life. It has application potential in the in-situ conversion and utilization of Martian CO2 resources. We simulate the CO2 atmosphere of Mars where the pressure is fixed at 1 kPa and the temperature is maintained at room temperature. A comparative study is carried out on the discharge characteristics of two typical electrode structures (with/without barrier dielectric) driven by 20 kHz AC voltage. Combined with numerical simulations, the CO2 discharge characteristics, products and their conversion pathways are analyzed. The results show that the discharge mode changes from single discharge during each half cycle into multi discharge pulses after adding the barrier dielectric. Each discharge pulse of the multi pulses corresponds to a random discharge channel, which is induced by the distorted electric field of accumulated charge on the dielectric surface and the space charge. The accumulated charge on the dielectric surface promotes the primary discharge and inhibits the secondary discharge. Space charge will be conducive to the occurrence of secondary discharge. The main products in discharge process include \begin{document}${\rm{CO}}^+_2 $\end{document}, CO, O2, C, and O. Among the products, CO is produced mainly by the attachment decomposition reaction between energetic electrons and CO2 at the boundary of cathode falling zone, and the contribution rate of the reaction can reach about 95%. The O2 is generated mainly by the compound decomposition reaction between electrons and \begin{document}${\rm{CO}}^+_2 $\end{document} near the instantaneous anode surface or instantaneous anode side dielectric surface, and the contribution rate of the reaction can reach about 98%. It is further found that the dielectric does not change the generation position nor dominant reaction pathway of the two main products, but will reduce the electron density from 5.6×1016 m−3 to 0.9×1016 m−3 and electron temperature from 17.2 eV to 11.7 eV at the boundary of the cathode falling region, resulting in the reduction of CO production. At the same time, the deposited power is reduced, resulting in insufficient \begin{document}$ {\rm{CO}}^+_2 $\end{document} yield near the instantaneous anode surface and instantaneous anode side dielectric surface and further the decrease of O2 generation.

Study on Discharge Characteristics and Particle Distribution of Low-Pressure CO<sub>2</sub> Dielectric Barrier Discharge

Study on Discharge Characteristics and Particle Distribution of Low-Pressure CO<inf>2</inf> Dielectric Barrier Discharge

Comprehensive study on discharge characteristics in pulsed dielectric barrier discharges with atmospheric He and CO2

Study of Characteristics of Coplanar Dielectric Barrier Discharge

The Mutual Conversion of CO2 and CO in Dielectric Barrier Discharge (DBD)

Influence of Gas Flow on Discharge Mode in Coaxial Argon DBD under Atmospheric Pressure

Particle simulation of mode transition in dielectric barrier discharges at different gas pressures

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Simulation Study on the Mechanism of Wire– Cylinder Air Dielectric Barrier Discharge Under Atmospheric Pressure

Numerical simulation of air DBD under standard atmospheric pressure

Full cycle, self-consistent, two-dimensional analysis of a packed bed DBD reactor for plasma-assisted $\mathrm{CO_{2}}$ splitting: spatiotemporal inhomogeneous, glow to streamer to surface discharge transitions

Investigation of Pulse Parameters on CO<inf>2</inf> Splitting to O<inf>2</inf> by Dielectric Barrier Discharge Plasma at 1kPa

Transition from Glow-Like to Streamer-Like Discharge in Atmospheric Pressure Dielectric Barrier Discharge Controlled by Variable Dielectric Surface Layer Permittivity

Comparative Study on Discharge Characteristics of Low Pressure CO2 Driven by Sinusoidal AC Voltage: DBD and Bare Electrode Structure

Investigation of Pulse Parameters on CO2 Splitting to O2 by Dielectric Barrier Discharge Plasma at 1kPa

Investigation of Surface Charge Distribution and Its Influence on Characteristics of Dielectric Barrier Discharge

Discussion on the Influences of Townsend Ionization Coefficient Α and Secondary Electron Emission Coefficient Γ on the Characteristics of DBD

Comparative Study of Homogenous Dielectric Barrier Discharge in Atmospheric Inert Gases

Optical and Electrical Characteristics of Air Dielectric Barrier Discharges in Mode Transition at Atmospheric Pressure

Discharge Characteristics Of Argon Atmosphere Dielectric Barrier With Different P D Values

Two-dimension Simulation of Small Scale Dielectric Barrier Discharge in Argon