Abstract:Heavy metal ions such as hexavalent chromium (Cr(VI)) existed in wastewater have caused serious pollution problems. Cr(VI) is teratogenic and carcinogenic, while trivalent chromium (Cr(III)) is an essential nutrient for humans and animals. Adsorption method can transfer Cr(VI) from liquid phase to absorbent surface, but it needs follow-up treatment to remove Cr(VI). Photocatalysis technique can reduce Cr(VI) to Cr(III), so as to decrease its toxicity, but the adsorption capacity towards Cr(VI) is always small due to poor surface area of some traditional semiconductor oxide photocatalysts. Therefore, a new material with both good adsorption capacity and photocatalytic activity is needed for Cr(VI) removal. As an emerging kind of carbon materials, graphene oxide (GO) has attracted particular attention in the catalysis field. Graphene oxide aerogel (GOA), a three dimensional nanomaterial, possesses numerous adsorption sites and superior ability to accept and transport photogenerated electrons, would thus present good adsorption capacity and high photocatalytic performance simultaneously. So far, most studies on GO-base material are towards investigating its co-catalyst role (adsorption enhancement or electron shuttle) in improving efficiency of metal or semiconductor photocatalysts. Only a few studies have applied GO-base material as a sole photocatalyst. In this study, combined with the cross-linking method and the supercritical CO2 fluid extraction method, three-dimensional porous and recyclable GOA with large specific surface area and defect sites was prepared by using GO as the precursor. The physicochemical properties were characterized by SEM, XRD, Raman spectroscopy and nitrogen adsorption methods. The adsorption behavior and photocatalytic reduction performance of GOA towards Cr(VI) under visible light were investigated. GO was hydrothermally reduced during the preparation process. and many defects were generated on GO sheets. Melamine and cyanuric acid were used as crosslinking agents to increase the interlayer spacing. and at the same time providing GOA a large specific surface area and a rich porous structure. When the mass ratio of GO, melamine. and cyanuric acid was 3:3:3 and the GO concentration was 6 mg L-1, GOA exhibited the largest specific surface area and defect density. This kind of GOA, i.e., GOA(333)(-6) presented the best adsorption capacity and photocatalytic efficiency of Cr(VI). The adsorption behavior of GOA on Cr(VI) fits to the quasi-second-order kinetic model and the Langmuir adsorption isotherm model, indicating that the adsorption process was a single-layer chemical adsorption, in which the intra-particle diffusion in the initial adsorption stage was the rate-limiting step. The three-dimensional graphene oxide aerogel GOA obtained in this study exhibited large adsorption capacity, high photocatalytic removal efficiency for high concentration Cr(VI) under visible light, and good repeatability. Single GOA material has potential application in removing heavy metal ions from polluted wastewater.

Efficient Removal of Cr(VI) by a 3D Z-scheme TiO2-ZnxCd1-xS Graphene Aerogel Via Synergy of Adsorption and Photocatalysis under Visible Light

Visible-light-driven Ag3VO4-BiVO4/C3N4 with Continuous Type II Heterojunctions for Effective Removal of Cr(VI)

Removal of Cr(VI) by 3D TiO2-graphene Hydrogel Via Adsorption Enriched with Photocatalytic Reduction

High Efficient Adsorption and Photocatalytic Removal of Hexavalent Chromium over Three-Dimensional Grapheneoxide Aerogel under Visible Light

Cr(VI) Reduction in Presence of ZnS/RGO Photocatalyst under Full Solar Spectrum Radiation from UV/vis to Near-Infrared Light

Plasmonic Ag Modified Ag3VO4/AgPMo S-scheme Heterojunction Photocatalyst for Boosted Cr(VI) Reduction under Visible Light: Performance and Mechanism

A Novel Visible Light-Driven TiO2 Photocatalytic Reduction for Hexavalent Chromium Wastewater and Mechanism

Construction of a recyclable dual-responsive TiO2-based photocatalyst modified with ZnIn2S4 nanosheets and zinc phthalocyanine for Cr(VI) reduction under visible light

Efficient Removal of Cr(VI) by TiO2 Based Micro-Nano Reactor via the Synergy of Adsorption and Photocatalysis

Efficient Photocatalytic Reduction of Chromium (VI) Using Photoreduced Graphene Oxide As Photocatalyst under Visible Light Irradiation

Synergistic Adsorption and Photocatalytic Reduction of Cr(VI) Using Zn-Al-layered Double Hydroxide and TiO2 Composites

Visible-light-driven CQDs/TiO2 photocatalytic simultaneous removal of Cr(VI) and organics: Cooperative reaction, kinetics and mechanism

RGO-wrapped Ti3C2/TiO2 nanowires as a highly efficient photocatalyst for simultaneous reduction of Cr(VI) and degradation of RhB under visible light irradiation

Reduced graphene oxide supported ZnO/CdS heterojunction enhances photocatalytic removal efficiency of hexavalent chromium from aqueous solution

Facile Fabrication of "green" Sns2 Quantum Dots/Reduced Graphene Oxide Composites with Enhanced Photocatalytic Performance

Porous carbon nanofiber/porphyrin-based metal organic frameworks/TiO 2 nanoparticles ternary materials for selective detection and photoreduction of Cr(VI)

Fabrication of AgBr/boron-doped reduced graphene oxide aerogels for photocatalytic removal of Cr(VI) in water

Fabrication of Z-scheme Bi7O9I3/g-C3N4 heterojunction modified by carbon quantum dots for synchronous photocatalytic removal of Cr (VI) and organic pollutants

Construct interesting CuS/TiO2 architectures for effective removal of Cr(VI) in simulated wastewater via the strong synergistic adsorption and photocatalytic process

Removal of Chromium (VI) by a Self-Regenerating and Metal Free G-C3n4/graphene Hydrogel System Via the Synergy of Adsorption and Photo-Catalysis under Visible Light

Efficient photo-assisted reduction of Cr(VI) via activated carbon mediated Z -scheme FeS 2 /α-FeOOH/C heterojunction: Focusing on molecular oxygen fate and synergetic reduction mechanism