Abstract:The 20kt Liquid Scintillator (LS) JUNO detector is being constructed by the International Collaboration in China, with the primary goal of addressing the question of neutrino mass ordering (hierarchy). The main challenge for JUNO is to achieve a record energy resolution, ~3% at 1MeV of energy released in the LS, which is required to perform the neutrino mass hierarchy determination. About 20 000 large 20-inch PMTs with high Photon Detection Efficiency (PDE) and good photocathode uniformity will ensure an approximately 80% surface coverage of the JUNO detector. The JUNO collaboration is preparing equipment for the mass tests of all PMTs using 4 dedicated containers. This approach allows us to test 144 PMTs in parallel. The primary measurement in the container will be the PMT response to illumination of its photocathode by a low-intensity uniform light. Each of the 20 000 PMTs will undergo the container test. Additionally, a dedicated scanning system was constructed for sampled tests of PMTs that allows us to study the variation of the PDE over the entire PMT photocathode surface. The core of the scanning station is a rotating frame with 7 LED sources of calibrated short light flashes that are placed along the photocathode surface covering zenith angles from the top of a PMT to its equator. The collection efficiency of a large PMT is known to be very sensitive to the Earth Magnetic Field (EMF), therefore, understanding the necessary level of EMF suppression is crucial for the JUNO Experiment. A dark room with Helmholtz coils compensating the EMF components is available for these tests at a JUNO facility. The Hamamatsu R12860 20-inch PMT is a candidate for the JUNO experiment. In this article the container design and mass-testing method, the scanning setup and scanning method are briefly described and preliminary results for performance test of this PMT are reported.

Performance Test and Qualification of the Photomultiplier Tube for the Whole Production of LHAASO-ED

Setup of a photomultiplier tube test bench for use at LHAASO-KM2A

A Versatile Test Bench for Photomultiplier Tube Characterization and Its Application in the DAMPE-PSD

Performance testing of a novel short axis photomultiplier tube for the HUNT project

High dynamic range base design and characterization of an 8-inch photomultiplier tube CR365-02-2 for the LHAASO-MD experiment

The Large PMT Quantum Efficiency Test Platform

A versatile PMT test bench and its application in the DAMPE-PSD

Acceptance tests of Hamamatsu R7081 photomultiplier tubes

Photomultiplier Tube Selection for the Wide Field of View Cherenkov/fluorescence Telescope Array of the Large High Altitude Air Shower Observatory

Quality control of mass production of PMT modules for DAMPE

Study on the Performance of Electromagnetic Particle Detectors of Lhaaso-Km2a

Characterization of HZC XP1805 photomultiplier tube for LHAASO-WCDA with a high dynamic range base

A performance evaluation system for photomultiplier tubes

Performance of SiPMs and Pre-Amplifier for the Wide Field of View Cherenkov Telescope Array of LHAASO

Afterpulse measurement for 8-inch candidate PMTs for LHAASO

Automatic test system development for digital beam position monitor of HEPS and BEPCII

The DAQ Ssystem and the Experiment Setup of the PMT Test System in CDEX-10

Large photocathode 20-inch PMT testing methods for the JUNO experiment

Evaluation of the Prototype Front End Electronics of WCDA in LHAASO

Development of the Large Area MCP-PMT