Abstract:Ammonia (NH3) is one of the most frequently produced chemical products in the world, and it plays an indispensable role in life on Earth. However, its synthesis by the Haber-Bosch (H-B) process is highly energy intensive, resulting in extensive carbon emissions that are unsustainable due to their ability to harm the environment. Herein, we propose a facile and mass-producible strategy for increasing the rate and efficiency of nitrogen fixation through the use of copper particle-catalyzed Li nitridation and a solid electrolyte as a medium to reduce Li salt; the above strategy results in the conversion of water and nitrogen into NH3 through the use of renewable electrical energy at room temperature and atmospheric pressure. Copper particles are uniformly pressed into Li metal by a simple rolling method, and their critical role in accelerating the nitrogen fixation process is revealed by both electrochemical tests and simulations. The nitridation of the Li in the composite is reduced to a few minutes instead of the more than 40 h that are needed for bare Li and N2 at room temperature and atmospheric pressure. Our new method provides three important advantages over the H-B method: (1) the new method can be operated at atmospheric pressure, thereby lowering equipment requirements and increasing security; (2) the use of water instead of fossil fuels as a hydrogen source decreases the consumption of these fuels and the emission of CO2; and (3) the low equipment requirements lead to the ready miniaturization and decentralization of the NH3 synthesizing process, thus promoting the possible use of renewable sources of electricity (e.g., wind or solar energy).

Mechanochemical Synthesis of Ammonia Employing H2O As the Proton Source under Room Temperature and Atmospheric Pressure

Mechanocatalysis: Simple and Rapid Mechanochemical Synthesis of Ammonia in Hydrogen, Nitrogen, and Water System

Copper Particle-Enhanced Lithium-Mediated Synthesis of Green Ammonia from Water and Nitrogen

The Journey toward Low Temperature, Low Pressure Catalytic Nitrogen Fixation

Ambient Electro-Synthesis of Ammonia - Electrode Porosity and Composition Engineering

Mechanochemistry for ammonia synthesis under mild conditions

Catalytic Nitrogen Fixation Using Well‐defined Molecular Catalysts under Ambient or Mild Reaction Conditions

Ambient Electrosynthesis of Ammonia: Electrode Porosity and Composition Engineering

Atomically Dispersed Manganese Lewis Acid Sites Catalyze Electrohydrogenation of Nitrogen to Ammonia

Review on photocatalytic and electrocatalytic artificial nitrogen fixation for ammonia synthesis at mild conditions: Advances, challenges and perspectives

Electrochemical Synthesis of Ammonia by Zirconia-Based Catalysts at Ambient Conditions

Selective N2/H2O adsorption onto 2D amphiphilic amorphous photocatalysts for ambient gas-phase nitrogen fixation

Ambient Electrochemical Nh3 Synthesis From N-2 And Water Enabled By Zro2 Nanoparticles

Radiocatalytic ammonia synthesis from nitrogen and water

Synthesis of ammonia directly from air and water at ambient temperature and pressure

Highly Efficient Nitrogen Reduction to Ammonia through the Cooperation of Plasma and Porous Metal‐Organic Framework Reactors with Confined Water

(Invited) Electrochemical Nitrogen Fixation under Ambient Conditions

Electrocatalytic Production of Ammonia: Biomimetic Electrode–electrolyte Design for Efficient Electrocatalytic Nitrogen Fixation under Ambient Conditions

(Invited) Lithium-Mediated Ammonia Synthesis at Ambient Conditions

Fe-Mg alloy nitrogen carrier for chemical looping ammonia synthesis process formed by mechanochemical nitrogen fixation and heating hydrogenation

High-performance artificial nitrogen fixation at ambient conditions using a metal-free electrocatalyst