Abstract:Thermoelectric generators can generate electricity directly from low-temperature energy sources, such as solar and geothermal energy. Because of the low heat flux of the heat source, heat pipes are used to increase the hot end temperature of the thermoelectric module, and thus improve its conversion efficiency. We developed a heat pipe thermoelectric generator and quantitatively studied the effects of the heating power of the heat pipe evaporator and the number of modules used in the condenser, on the thermoelectric performance, heat transfer characteristics, and temperature uniformity of the generator. As the heating power increased, the heat pipe thermal resistance decreased, and the thermoelectric conversion efficiency increased. As the number of thermoelectric modules increased, the proportion of heat pipe thermal resistance increased and became dominant, which caused the hot end temperature of the modules to decrease. The system attains maximum efficiency when there is only a single module at the condenser. The temperature of the evaporator can be effectively increased to improve the output power. When the temperature of the evaporator remained constant, increasing the number of modules reduced the temperature of the hot end slightly, however, the output power was greatly improved, and the maximum output power reached 10.85 W with four modules used in the experiment. The non-uniformity of the module output performance was obvious at a low heat flux, and the module output power was high near the evaporator. These results contribute to understanding the working characteristics of heat pipe thermoelectric generators and provide some guiding significance for the optimization of generator operations.

Study on Cold Sider Heat Transfer of Foil Sealed Thermoelectric Generator Module for Hydrothermal Vent

Multiphysics Co-Simulation and Experimental Study of Deep-Sea Hydrothermal Energy Generation System

A New Seafloor Hydrothermal Power Generation Device Based on Waterproof Thermoelectric Modules

A Novel Plate-type Thermoelectric Power Generation Module for Seafloor Hydrothermal Fluids

Titanium Foil-Sealed Thermoelectric Generator for Seafloor Hydrothermal Vent

Efficiency and Power Density Analysis on Phase Change Material-Based Ocean Thermoelectric Generator for Underwater Vehicle

Research on Heat Dissipation Mechanism of the Power Supply in Seafloor Observation Network Junction Box

Generation of Electricity from Deep-Sea Hydrothermal Vents with A Thermoelectric Converter

Hydrothermal Fluid Ejector for Enhanced Heat Transfer of a Thermoelectric Power Generator on the Seafloor

Heat Transfer Characteristic Of A Hydrothermal Energy Converter

A Thermoelectric Cap for Seafloor Hydrothermal Vents

Heat sink design for thermoelectric generation in spindle unit

Improving the Efficiency and Pressure Resistance of Inorganic Sealant–Filled Thermoelectric Module

Battery-free Temperature Logger for Deep-Sea Hydrothermal Fluids Based on Heat Pipe Heat Exchangers and Thermoelectric Generators.

Experimental investigation of heat pipe thermoelectric generator

Experimental Study on Thermosyphon Heat Sink for Cooling of Electronic Apparatus

Active temperature-preserving deep-sea water sampler configured with a pressure-adaptive thermoelectric cooler module

THE APPLICATION RESEARCH OF HEAT SOURCE AND HEAT SINK IN MICRO (MINI) THERMOELECTRIC DEVICE

Study of Thermal Insulation Materials Influence on the Performance of Thermoelectric Generators by Creating a Significant Effective Temperature Difference

Research on an Active Heat Insulation Device for the Hadal Sample

Numerical Investigation of a Novel Heat Exchanger in a High-Temperature Thermoelectric Generator