Abstract:Ventilation and air distribution systems for cleanrooms in electronic industry have been overdesigned. Reducing the air supply volume of fan filter units (FFUs) is considered an energy saving measure. However, little is known about the particle removal performances after reduction in air supply volume. In this study, experiments were conducted in a chamber to investigate the effects of reducing air supply volume on the characteristic of particle distribution. The experiments were based on three FFU speed ratios (80%, 50%, and 40%) and four particle source locations (source in the subzone with and without an FFU at the heights of 1.5 m and 1.0 m) at two FFU area ratios (50% and 25%). The results were analyzed using the dimensionless particle concentrations (with respect to ideal mixing condition) in sixteen subzones within the experimental region. It was concluded that (1) the containment effect of air distribution on particle lateral dispersion was weakened with the decrease of air supply volume for FFU area ratios of both 50% and 25%; (2) most subzones have been well protected at an FFU area ratio of 50% (with dimensionless concentrations far below 0.2) regardless of the source location, and at an FFU area ratio of 25% (with dimensionless concentrations far below 0.5) for the particle source under an FFU supply airflow. However, the containment effect has been poor at an FFU area ratio of 25% for the particle source not under an FFU supply airflow regardless of the air supply volume; (3) the working face at a height of 1.0 m was slightly more affected for a source height of 1.5 m compared with a source height of 1.0 m at an FFU area ratio of 50%, while there was no significant difference in the particle removal for both source heights at an FFU area ratio of 25%; and (4) the air supply volume could be reduced by 46.7% (0.2 as the critical value) and 43.8% (0.5 as the critical value), respectively for FFU area ratios of 50% and 25% from the perspective of air distribution effectiveness. This study improves the understanding of characteristics of reduced airflow in cleanrooms.

Study on Self-Cleaning Time and Suspended Particle Distribution in Medical Clean Room

Numerical Comparison of the Efficiency of Mixing Ventilation and Impinging Jet Ventilation for Exhaled Particle Removal in a Model Intensive Care Unit

Experimental Characterization of Particle Distribution During the Process of Reducing the Air Supply Volume in an Electronic Industry Cleanroom

Experimental Investigation of Particle Dispersion in Cleanrooms of Electronic Industry under Different Area Ratios and Speeds of Fan Filter Units

Capturing Energy-Saving Opportunities in Air-Supply System for Cleanroom with Non-Unidirectional Airflow

Regional flow motion and heat energy balance analysis of a 10,000 class pharmaceutical cleanroom with secondary return air conditioning system

Indoor Airflow and Pollutant Spread Inside the Cleanroom with Micro-Porous Supplying Panel and Different Ventilation Schemes: Analytical, Numerical and Experimental Investigations

Field Test of Pharmaceutical Cleanroom Cleanliness Subject to Multiple Disturbance Factors

Analysis and Experiments on the Characteristics of Airflow and the Air Cleanliness Protection Region under Fan Filter Units in Cleanrooms

Impact of the Speed of Airflow in a Cleanroom on the Degree of Air Pollution

Improvement of Airflow Distribution and Contamination Control for a Biotech Cleanroom

DISCUSSION OF FACTORS THAT EFFECT AIR PERFORMANCE OF UNIDIRECTIONAL-FLOW CLEANROOMS

Cleaning performance evaluation of mobile operation shelter under dynamic disturbance

Numerical assessment of ceiling-mounted air curtain on the particle distribution in surgical zone

Simulation on interface airflow by occupant's traffic flow through operating room

Effect of ACH on contamination diffusion in turbulent cleanroom

Numerical Investigation of Particle Diffusion in A Clean Room

Theoretical expression for clean air volume in cleanrooms with non-uniform environments

Comparison of indoor environment of a locally concentrated cleanroom at occupied and unoccupied status by numerical method

Numerical Simulation on Air Distribution and Aerosol Transportation in Operating Room with Unidirectional Flow System under Operational Condition

Optimization of Bathroom Ventilation Design for an Iso Class 5 Clean Ward