Abstract:Fuel injection is one of the most important processes in compression-ignition internal combustion engines owing to its significant impact on the exhaust emissions and thermal efficiency. In this study, experiments were carried out to investigate the influence of injection pressure and injection timing on the temporal evolution of the injection rate and injection duration in a specially designed experiment rig equipped with a common rail injection system. It is well known that the injection signal from the electronic control unit (ECU) of the injection system, which is often the only injection information available in engine operation and experiments, gives little information about the actual injection rate profile. It is shown in the present experiments that the actual injection duration is usually longer than the energizing time (ET). The time delay between the actual injection of the fuel and the ECU signal is about 0.3-0.4 ms, and the time delay appears to be insensitive to the injector geometry and injection pressure condition. The injection process can be characterized as five stages, a fast injector valve opening stage, a slow valve opening stage, a valve fully open stage, followed by a slow valve closing stage, and finally a rapid valve closing stage. It is found that the first stage, the fast valve opening stage, is insensitive to the injection pressure and injector nozzle diameter; however, the peak injection rate is a strong function of these parameters. The second and the third stage may not appear with a short injection duration. A new injection model was developed for the common rail injection system, which was capable of simulating the instantaneous fuel injection rate and injection duration for a range of injection pressure and injection duration. The model was shown to be able to replicate the experimental injection rate profile of the present experiments and experiments found in the literature for common rail injection system. The new injection model was applied to predict the effect of injection pressure and injection duration on the performance of a diesel engine under various engine speed and load conditions. The new injection model was shown to be able to describe the injection mass flow rate, which eventually leads to a reasonably good prediction of the variations of the spray development, in-cylinder pressure, heat release rate, and emissions.

Investigation of a Method for Online Measurement of Injection Rate for a High-Pressure Common Rail Diesel Engine Injector under Multiple-Injection Strategies

An on-line measurement method of injection rate of high pressure common rail system

Investigation of fuel injection rate identification algorithm based on rail pressure fluctuation characteristics induced by injection

Hybrid Data-Driven and Mechanism-Modeling Approaches for Online Injection Rate Sensing of Dual-Fuel Co-Direct Injector under Carbon Neutral Background

Real-time Estimation of Fuel Injection Rate and Injection Volume in High-Pressure Common Rail Systems

Simultaneous Measurement and Analysis of Gas Needle Lift and Injected Rate for HPDI Fuel Injector

An Innovative Rail Pressure Sensor Signal Processing Algorithm to Determine the Start of Injection and End of Injection of Diesel Engines With Common Rail Injection Systems.

Study on Online Identification Method of Injection Time Characteristics for the High Pressure Diesel-Natural Gas Co-direct Injection Engine

Measurement and Verification of Transient Injection Flow Rate of High Pressure Natural Gas Pulse Injector

Method study for RT-Flex HPCR low-speed diesel engine injecting law measuring

Investigation on online perception method of gas injection characteristics for the high-pressure natural gas direct injection engine

Investigation of Main Injection Quantity Fluctuation Due to Pilot Injection in High Pressure Common Rail Fuel Injection System

Characteristics of Pressure Wave in Common Rail Fuel Injection System of High-Speed Direct Injection Diesel Engines

A calculation method and experiment study of high-pressure common rail injection rate with solenoid injectors

Common rail injection system on-line parameter calibration for precise injection quantity control

Experimental and Modeling Study of Liquid Fuel Injection and Combustion in Diesel Engines with a Common Rail Injection System

A control-oriented approach to estimate the injected fuel mass on the basis of the measured in-cylinder pressure in multiple injection diesel engines

Pressure-Based Approach to Estimating the Injection Start and End in Single and Split Common Rail Injection Processes

A Study on the Monitoring Technique for the Dynamic Response Characteristics of High Pressure Common Rail Fuel Injector

A measurement method for the dual fuel coupling injection characteristics of the high-pressure natural gas and diesel co-direct injection engine

Common rail injection system iterative learning control based parameter calibration for accurate fuel injection quantity control