Abstract:This work presents a low-noise and high-rate front-end readout ASIC for the electromagnetic calorimeter in the super tau-charm factory. The chip is designed to process signals generated from avalanche photodiode detectors. A low-noise preamplifier and a 5th-order high-linearity shaper with controllable shaping times were proposed to decrease noise induced by the 270pF detector capacitance. A peak detect-hold circuit and a high-linearity differential analog buffer convert each peak voltage of the shaper to differential voltages with strong driving capability. A fast shaper and a discriminator are implemented to produce trigger signals, which contain the arrival timing information of the input signals. The output data can be digitized on-chip by a 12 bit 10 MS/s pipelined successive approximation ADC and a 16 bit three-stage TDC. The preliminary experimental results have been obtained. The input charge range is from 4.8fC to 400fC. The maximum count rate is up to 1Mcps at the peaking time of 200ns. The measured nonlinear error of the system is less than 2.5%. The equivalent noise charge is 898 e - + 5.2 e - /pF. The timing resolution is better than 632ps at an input charge of 100fC. The effective resolution of the ADC is 10.65-bit when operated at 10 MS/s. The chosen technology is a standard commercial 1P6M 0.18μm mixed-signal CMOS process and the chip area occupancy is 2.4 x 1.6 mm 2 .

Design of Second Version Driver and Readout ASICs for Scientific CCD Detectors

Design and test of driver and readout ASICs for scientific CCD detectors

Design of Two ASIC Chips for Scientific CCD Detectors

A Driver ASIC for Scientific CCD Detectors Using 180nm Technology

Design of a Scientific CCD Camera Based on CCD Driving and Readout ASIC Chips

Design of CCD Test Platform of Scientific Imaging for Wide Field Survey Telescope

A Project Plans to Develop Two ASICs for CCD Controller

The Bias And Clock Drive Asic For Astronomical Ccd Controller

The Design of the CCD Driver Module Based on FPGA

Design of the Electronic System for a 2×2 Mosaic CCD Camera

Testing of Front-End Readout Prototype ASICs Designed for WCDA in LHAASO

The Design of a Fast Front-end Readout ASIC for Time Correction with Low Voltage

Design of the Electronic System for a Mini Single CCD Camera Based on ASIC

A multichannel front end ASIC for PMT readout in LHAASO WCDA

Design of a Non-vacuum-cooling Compact Scientific CCD Camera

Design of a Pixel Readout ASIC Using Super Pixel Circuits with a Built-in LDO Regulator for Hybrid X-ray Imaging Detectors

Test System of the Front-End Readout for an Application-Specific Integrated Circuit for the Water Cherenkov Detector Array at the Large High-Altitude Air Shower Observatory

Design and Performance of a 16-Channel Radiation-Hardened Low-Noise Front-End Readout ASIC for CZT-based Hard X-ray Imager

Design and Development of a Front-End Readout ASIC for APD-Based STCF Electromagnetic Calorimeter

Design of a Nonvacuum-Cooling Compact CCD Camera for Scientific Detection

The Signal Processing ASIC for Astronomical CCD Controller