Parametric Study of Alfvénic Instabilities Driven by Runaway Electrons During the Current Quench in DIII-D

A. Lvovskiy,C. Paz-Soldan,N. W. Eidietis,A. Dal Molin,G. H. DeGrandchamp,E. M. Hollmann,J. B. Lestz,C. Liu,M. Nocente,D. Shiraki,X. D. Du
DOI: https://doi.org/10.1088/1741-4326/acb725
IF: 3.3
2023-01-01
Nuclear Fusion
Abstract:To avoid or mitigate runaway electron (RE) beams in ITER, RE-driven instabilities are actively studied as a complimentary technique to massive material injection. In this work we report experimental dependencies of Alfvenic instabilities driven by REs during the current quench in DIII-D on plasma and material injection parameters. These instabilities, observed in the frequency range of 0.1-3 MHz, correlate with increased RE loss and thus may play a role in non-sustained RE beams. It was found that as the toroidal magnetic field (B-T) decreases, the RE population becomes more energetic, the energy of instabilities increases, and no RE beam is observed when the maximum energy of REs exceeds 15 MeV (or when B-T is below 1.8 T). Analysis of disruptions at plasma core temperature (T-e) of 1 keV and 8 keV shows that the RE population is much less energetic (with the maximum energy of only about 3 MeV) when Te is high, and no instabilities are observed in this case. Besides disruptions above caused by Ar injection, cases with Ne and D-2 injections were also studied. Both Ne and D-2 injections cause no sustained RE beams, however, for different reasons. Measurements of the instability polarization indicate that it is of predominantly compressional nature at the edge, which is consistent with modeling suggesting excitation of compressional Alfven eigenmodes. However, drive of global Alfven eigenmodes is also possible at low frequencies.
What problem does this paper attempt to address?