Performance of a Modified Alkaline Lignin Towards Copper Adsorption under Different Conditions
Chunli Zheng,Qiaorui Wang,Yujie Dai,Bo Zu,Yangyang Zhang,Tian C. Zhang
DOI: https://doi.org/10.4491/eer.2021.097
2021-01-01
Environmental Engineering Research
Abstract:Polyethyleneimine and carbon disulfide were employed to modify alkaline lignin (AL) in order to introduce -NH, -NH2 and -CSSgroups. Its adsorption performance towards Cu(II) was evaluated based on the residual concentration (Cr) against the discharge permissible concentration for Cu(II) (2.0 mg/L) established by the World Health Organization. The evaluation was operated under different conditions such as adjusting the solution pH, Cu(II) coexisting with K(I), Na(I), Ca(II) or Mg(II), changing the contact time (t) and initial concentration of Cu(II) (C0), as well as regeneration. When t and C0 equaled to 180 min and 50 mg/L, Cr was less than 2.0 mg/L at pH of 5.03 to 5.65. Under the situation of Cu (II) coexisting with 50 mg/L of K(I), Na(I), Ca(II) or Mg(II), Cr was as low as 1.96, 1.53, 1.97 or 1.55 mg/L (t = 180 min, C0 = 50 mg/L), respectively. Even the modified AL was regenerated and reused four times, Cr was closed to 2 mg/L for each time (t = 180 min, C0 = 51 mg/L). By comparing with other lignin-based materials according to the adsorption equilibrium time, the maximum adsorption capacity, and Cr, the modified AL exhibited higher application potential in copper-loaded water treatment.