Abstract:Fully-transparent deep-sea pressure hulls have been attracted attention in recent years with the increasing demand for underwater observation. So far, public researches on design rule and failure modes for fully-transparent deep-sea pressure hulls are limited and the relevant experience cannot meet the requirements of new cabin design. In this study, the compression test is carried on, in which the material samples are subjected to quasi-static compressive load until failure in tests at different loading rates, and the hyperelastic finite element model is established in LS-DYNA software to simulate the failure process. Simulation results of material properties in finite element analysis on the cylindrical samples are compared with the experimental data, including the characteristic points of the mechanical properties in elastic stage and hardening stage, the ultimate load and failure mode of the samples. Mesh convergence analysis is conducted, and the appropriate mesh quality is accordingly selected in simulation of fully-transparent deep-sea pressure hulls. An equation for prediction of instability-type failure is described, which is derivation based on the classical analytical expression of elastic instability, thus, when 5 times of safety factor is taken, the wall thickness of the pressure hull is calculated to be t/R 0 = 0.0685 at 2,500 m depth. Ultimate strength and failure mode of a typical fully-transparent deep-sea pressure hull are simulated. First, the first-order linear buckling modal analysis is carried out to simulate initial geometric imperfections. Then, simulations for the loading and collapse process of two fully-transparent pressure hulls respectively with one opening and two openings are conducted, and the ultimate load of 126 MPa and 128 MPa for the two kinds of hulls are obtained. Finally, simulation of a scaled pressure hull is carried out and simulation results are compared with the experimental data in reference, which are basically consistent. The calculated failure strength shows that the spherical hulls satisfy the safety factor requirement of 5 times. The provided simulation procedure can be referred for failure analysis of fully-transparent pressure hulls.

DESIGN AND STRUCTURAL ANALYSIS SUBMARINE AUV PRESSURE HULL WITH DIFFERENT MATERIALS

Mechanical Analysis and Optimal Design for Carbon Fiber Resin Composite Wound Hydrogen Storage Vessel With Aluminum Alloy Liner

Structural Design and Strength Analysis on Framework for Deep Sea Manned Submersible

Design and Testing of a Composite Pressure Hull for Deep Autonomous Underwater Vehicles

Micromechanics-based Progressive Failure Analysis of Carbon FIber/epoxy Composite Vessel under Combined Internal Pressure and Thermomechanical Loading

Pressure Hull Design Methods for Unmanned Underwater Vehicles

Experimental and numerical buckling analysis of cylindrical pressure hulls with multi-circular openings

Analysis of plated-hull structure strength against hydrostatic and hydrodynamic loads: A case study of 600 TEU container ships

Design Parameters of Testing Vessel for Deep Sea Experiments: A Review on Findings

Analysis of thick-walled spherical shells subjected to external pressure: Elastoplastic and residual stress analysis

Failure Behavior of Corrugated Pressure Cylindrical Shells with Variable Wall Thickness under Uniform External Pressure

Strength optimization design of spherical hulls for deep-sea submersibles: A hydraulic autofrettage approach in external pressure vessels

Isogeometric Method for Buckling Prediction and Post-Buckling Analysis of Variable Stiffness Composite Underwater Pressure Shell

Optimal design and strength reliability analysis of pressure shell with grid sandwich structure

Design and Manufacturing Process of a New Type of Deep-Sea Spherical Pressure Hull Structure

Structural Selection and Numerical Analysis of Disk-Underwater Glider Pressure Shell

Parametric study of buckling and post-buckling behavior for an aluminum hull structure of a high-aspect-ratio twin hull vessel

Failure analysis on fully-transparent deep-sea pressure hulls used at 2,500 m depth

Design and Computational Modelling of AUV Tunnel Thruster Covers for Efficient Operation

Combined Composites Layup Architecture and Mechanical Evaluation of Type IV Pressure Vessels: A Novel Analytical Approach

Design, modeling and optimization of an adhesively bonded ring joint with U-section for ceramic cylindrical pressure hull of deep-sea underwater vehicles