Abstract:Large and downed woody fuels remaining behind a wildfire's flame front tend to burn in a smoldering regime, producing large quantities of toxic gases and particulate emissions, which deteriorates air quality and compromises human health. Smoldering burning rates are affected by fuel type and size, the amount of oxygen reaching the surface, and heat losses to the surroundings. An external wind has the dual effects of bringing fresh oxidizer to the fuel surface and porous interior, while at the same time enhancing convective cooling. In this work, a series of experiments were conducted on single and adjacent poplar dowels to investigate the effect of fuel geometry and wind speed on smoldering of woody fuels, including its burning rate and combustion products. Dowels had variable thickness (19.1 and 25.4 mm), aspect ratios, and arrangement (number of dowels and spacing between them). Using measurement of mass loss, CO, and HC production as indicators of the smoldering intensity, the results indicate that the arrangement of smoldering objects significantly affects burning rates and emissions. Specifically, spacings of 1/8 and 1/4 of the dowel thickness enhanced the smoldering process. The smoldering intensity was also enhanced by increased external wind (ranging between 0.3 m/s and 1.5 m/s), but its effect was dependent upon the spacing between the dowels. The convective losses associated with the spacing were further investigated with a simplified computational model. The simulations show that the wind significantly increases convective losses from the smoldering surfaces, which in turn may offset the increase in smoldering intensity related to the higher oxygen flux at higher wind speeds.

Heat Loss and Kinetic Effects on Extinction and Critical Self-Sustained Propagation of Forced Forward Smoldering

Mechanism of Flashback in Horizontal Smoldering of Polyurethane Foam: A Numerical Study

An Integral Model of Opposed Smoldering Combustion Propagation

Smouldering and Its Transition to Flaming Combustion of Polyurethane Foam: an Experimental Study

Smoldering and Spontaneous Transition to Flaming over Horizontal Cellulosic Insulation

Modelling the Combustion of Thermally Thick Biomass Particles

Effects of Atmospheric Oxygen on Horizontal Peat Smoldering Fires: Experimental and Numerical Study

Numerical Investigation of Downward Smoldering Combustion in an Organic Soil Column

Transition from Smouldering to Flaming Combustion of Pine Needle Fuel Beds under Natural Convection

Modeling of Two-Dimensional Natural Downward Smoldering of Peat

The Pyrolysis and Ignition of Charring Materials under an External Heat Flux

Extinction of Wood Fire: A Near-Limit Blue Flame above Hot Smoldering Surface

Pyrolysis and Ignition of Wood by Thermal Radiation

Thermal-balanced integral model for pyrolysis and ignition of wood

The Influence of Different External Heating Ways on Pyrolysis and Spontaneous Ignition of Some Woods

Experimental and numerical simulation of multi-component combustion of typical charring material

Firebrand Burning under Wind: an Experimental Study

Minimum oxygen supply rate for smouldering propagation: Effect of fuel bulk density and particle size

Smoldering of Wood: Effects of Wind and Fuel Geometry

Smouldering Limit in Frictional Heating of Wood - Pilot Study

Computational study of the effects of density, fuel content, and moisture content on smoldering propagation of cellulose and hemicellulose mixtures