Abstract:Photocatalytic hydrogen generation by solar energy is a promising approach to clean energy resource and has attracted great attention over the past decades. [1] Perovskites ABO3 structures provide the basic stable framework to both crystal and electronic structures modification, which have found extensive applications in photocatalysis, solar cells and photoelectrochemical (PEC) water splitting. [2] LaFeO3 has a suitable band gap of 2.07eV [3, 4] and exhibits excellent visible light photocatalytic performance. However, the poor charge transport and slow reaction kinetics at the surface [3, 4] are the main factors limiting its further improvement on photocatalytic application. To overcome these obstacles, transition metals (Mn, Co, Cu) are introduced into LaFeO3 and the photocurrent of 10% Cu doped sample is improved by three times than that of LaFeO3. The reduced charge transport resistance owing to the Fe3+ discharge is identified to benefit the PEC performance improvement after TM doping. On the other hand, the surface state of LaFeO3 is modified by electrodepositing of amorphous cobalt-phosphate (Co-Pi). It shows that the presence of Co-Pi down-shifts the onset potential by ~ 560 mV for anodic photocurrent and the improvement can be attributed to the enhanced water oxidation due to the CoII/CoIII-OH discharge on Co-Pi decorated layers. The transition anodic photocurrent is improved by about six times after Co-Pi coating under visible light at 0.50 V vs. Ag/AgCl and the electrochemical impedance spectroscopy certifies the enhanced charge transfer, which contributes to the meliorative anodic photocurrent. The incident photon-to-current conversion efficiencies of LaFeO3 can be promoted from 1.37% to 2.14% at 400 nm after Co-Pi coating. Our results demonstrate that modification of the electronic structure (TM doping) and surface state (Co-Pi coating) are the promising way to promote the photoconversion efficiency of LaFeO3-based PEC cells under visible light. References: X. Lu, S. Xie, H. Yang, Y. Tong, H. Ji, Chem. Soc. Rev., 43, 7581 (2014). Z. G. Yi and J. Ye, Appl. Phys. Lett., 91, 254108 (2007). K. M. Parida, K. H. Reddy, S. Martha, D. P. Das and N. Biswal, Int. J. Hydrogen Energy, 35, 12161 (2010). Q. Peng, B. Shan, Y. Wen and R. Chen, Int. J. Hydrogen Energy, 40, 15423 (2015).

Dealloying of Few Coating: from Disorder to Order

Enhanced Photoelectrochemical Water Splitting on Novel Nanoflake WO3 Electrodes by Dealloying of Amorphous Fe–W Alloys

Cobalt/nickel Oxide Nanosheet Arrays for Electrocatalytic Water Oxidation: Size Modulation, Composition/phase Control, and Surface Decoration

Attractive Electron Delocalization Behavior of FeCoMoPB Amorphous Nanoplates for Highly Efficient Alkaline Water Oxidation

Efficient Photoelectrochemical Water Splitting and Impedance Analysis of WO3−x Nanoflake Electrodes

Modification of the Electronic Structure and Surface State of LaFeO3 for Improved Visible Light Photoelectrochemical Water Oxidation

Facile Synthesis of a Micro–Nano-Structured FeOOH/BiVO4/WO3 Photoanode with Enhanced Photoelectrochemical Performance

Facile synthesis of FeCoW oxides: Effects of amorphous structure, electronic configuration and catalytic sites on water oxidation

A Facile Approach to Synthesize CoO-Co3O4/TiO2 NAs for Reinforced Photoelectrocatalytic Water Oxidation

Facile Synthesis of Tungsten Oxide Nanostructures for Efficient Photoelectrochemical Water Oxidation

Synergy of Ultrathin CoOx Overlayer and Nickel Single Atoms on Hematite Nanorods for Efficient Photo‐Electrochemical Water Splitting

Regulating Crystal Structure and Atomic Arrangement in Single-Component Metal Oxides through Electrochemical Conversion for Efficient Overall Water Splitting

Charge redistribution in FeOOH nanoarray by ecological oxygen-reduction deposition for boosting electrocatalytic water oxidation

A Chemical Dealloying Approach for Pt Surface-enriched Pt 3 Co Alloy Nanoparticles as Oxygen Reduction Reaction Electrocatalysts

Amorphous FeOOH Decorated CoSe2 Nanorod Heterostructured Arrays for Efficient Water Oxidation

Synthesis of Tungsten Trioxide/Hematite Core-Shell Nanoarrays for Efficient Photoelectrochemical Water Splitting

Layered Double Hydroxide Modified WO3 Nanorod Arrays for Enhanced Photoelectrochemical Water Splitting

Constructing Ultrathin W-Doped NiFe Nanosheets via Facile Electrosynthesis as Bifunctional Electrocatalysts for Efficient Water Splitting

Ultrathin NiMn-layered Double Hydroxide Nanosheets Coupled with Α-Fe2o3 Nanorod Arrays for Photoelectrochemical Water Splitting

Protected Hematite Nanorod Arrays with Molecular Complex Co-Catalyst for Efficient and Stable Photoelectrochemical Water Oxidation: Protected Hematite Nanorod Arrays with Molecular Complex Co-Catalyst for Efficient and Stable Photoelectrochemical Water Oxidation

Ni, Co, and Yb Cation Co-doping and Defect Engineering of FeOOH Nanorods As an Electrocatalyst for the Oxygen Evolution Reaction