Improvement of LiNi<sub>1/3</sub>Co<sub>1/3</sub>Mn<sub>1/3</sub>O<sub>2</sub> Cathode Materials by Nano-MgO Doping

LI Jie-Bin,XU You-Long,XIONG Li-Long,WANG Jing-Ping
DOI: https://doi.org/10.3866/pku.whxb20111104
2011-01-01
Acta Physico-Chimica Sinica
Abstract:Nano-sized M3O4 (M=Ni1/3Co1/3Mn1/3) powder with a spinel structure was prepared by sintering co-precipitated M(OH)(2) at 500 degrees C for 5 h. The so-obtained M,a, was then mixed with LiOH and different amounts of nano-Mga The mixture was sintered at 850 degrees C for 24 h to synthesize Li(Ni1/3Co1/3Mn1/3)(1-x)MgxO2 (x=0, 0.01, 0.02, 0.03, 0.04,0.05) cathode materials. The lattice parameters increased while the diffusion coefficients of Li+ ion showed an increasing and then decreasing trend with an increase in the amount of Mg substitution. Li(Ni1/3Co1/3Mn1/3)(0.98)Mg0.02O2 had the highest Li+ ion diffusion coefficients, which were 29.20x 10(-11) CM2.s(-1) for Li+ de-intercalation and 4.760x10(-11) cm(2).s(-1) for Li+ intercalation. Its discharge capacity at 30 rate was 139.3 mAh.g(-1), which is 9.5 mAh.g(-1) higher than that of the pristine material. Furthermore, its cycle performance was also improved significantly compared with the un-doped counterpart.
What problem does this paper attempt to address?