Abstract:For large size TFT-LCD displays, the black photo spacer (BPS) technology is adopted to replace the BM and PS (Photo Spacer) processes and shifted to the array substrate side in order to save the BM process and reduce panel costs. While the original BM process is the first production process, the new BPS process is located at the last process of the array. BPS exposure molding requires precise alignment using metal markers in the pre-array process to achieve fine patterns. Due to the low transmittance of BPS, it is very difficult to align the CCD by metal markers in the BPS pre-capture process. The principle of the exposure device to grasp the target is first analyzed, and then the BPS material with different transmittance is obtained by adjusting the composition of the BPS material. By exposure shaping of BPS materials with different transmittance, the minimum requirement of material transmittance during exposure alignment is studied to obtain the highest shading of BPS materials. The experimental results show that the wavelength of the NSK exposure machine alignment lamp source is located in the infrared region of 780 similar to 1 000 nm. When the transmittance of BPS material in this band is lower than 23%, the alignment fails. By using organic-inorganic mixed pigment components instead of organic black pigment components, nearly 90% transmittance can be obtained to meet the alignment requirements, and an optical density of 1.2/mu m can be obtained after curing and molding to meet the shading needs of BPS products. The optical index of BPS board produced by this method is up to standard.

The Study of Chromaticity Optimization for Photo Alignment IPS LCD

Lc Display Cell Photo-Alignment by A Super-Thin Azo-Dye Layer

Novel Transflective Lcd Based on Patterned Polarizer Using Photoaligrunent Technique

Liquid-Crystal Photoalignment by Super Thin Azo Dye Layer

P-232L: Late-News Poster: New Results on Bistable Photoaligned Ferroelectric LCDs: Grey Scale Generation, Stabilization and Passive Driving Scheme

Application of digital image processing in three colors' auto-focusing and auto-alignment of projection display

Some Progresses of Photoalignment Technique Applied in Liquid Crystal Nondisplay Field

P‐4.4: A Design to Improve the Uniformity of AMOLED Panel

The Color Temperature Adjusting Method for Multi-Primary Display Using Nonlinear Programming Problems

Influence of Black Photo Spacer Material for TFT-LCD on Mark Reading in Exposure Process

P-66: Near-eye Light Field Displays Optimization Based on Sub-pixel Structure of LCD

Pixel center estimation algorithms in three colors auto-alignment of projection display

Energy-saving optimizing method of color sets used for three-dimensional drawing for OLED (Organic Light Emitting Diode) display device

P‐137: Photoaligned Transflective Liquid Crystal Display with Single Cell Gap Using OCB and Low Twist Nematic Modes

An Image Quality Model For Optimizing Color Performance Of A Display System

Methods to Improve Colour Mismatch Between Displays

Improvement of TFT-LCD Area Image Sticking

Investigation on Improving Color Crosstalk for High-Transmittance TFT-LCDs

P‐138: Color Demura for LTPS TFT MicroLED Displays

P‐96: Alignment Optimization on Gen. 4.5 G for High‐framerate Ultra‐high‐resolution Ferroelectric Liquid Crystal Displays

Tuning Electro-Optical Characteristics through Polymerization Monomer Content in PSVA Liquid Crystal Displays: Simulation and Experimentation