Abstract:The modifications of impeller may show diverse impact on centrifugal pump operating in pump and turbine modes. To clarify this problem, the hydraulic performance of a low specific speed centrifugal pump operating in both modes was firstly obtained by CFD method and verified by experiment. Then, based on the single-factor design method, a series of calculations have been conducted to identify the effects of impeller geometry parameters on the hydraulic performance in different modes. The variations of head, shaft power and hydraulic efficiency curves with different impeller parameters were explored. It is found that compared with turbine, the pump shows a more obvious variation of head. The outlet angle has positive impact both on the head consumed by pump or generated by turbine. The change of turbine shaft power is apparently smaller than that of pump for different impeller geometry parameters. Only the outlet width somewhat changes the turbine shaft power. The hydraulic efficiency in both modes shows different variation under different impeller geometric parameters, while the hydraulic efficiency of both modes is reduced with the outlet angle increasing. Meanwhile, the response amount of hydraulic efficiency caused by certain change of impeller parameters was estimated by sensitivity analysis method. It is found that only the appropriate blade number and outlet width can improve the hydraulic performance both in pump and turbine modes. Eventually, the hydraulic loss, skin friction loss and theoretical analysis were performed to explore the reason of hydraulic performance variation due to different impeller parameters. The change of slip factor, impeller inlet area, impeller outlet area or hydraulic loss results in the change of hydraulic performance in both modes. The results can be useful for hydraulic performance improvement for both pump and turbine modes through impeller geometry modification.

Numerical Analysis on the Hydraulic Performance of the Auxiliary Impeller in Large Capacity Canned-Motor Pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Three-Dimensional Flow Field Numerical Simulation and Performance Analysis for A New Type Canned Motor Pump

Design and optimization of super-large capacity submersible axial-flow pump impeller

Numerical Simulation of Flow in Centrifugal Pump with Complex Impeller

Multistage auxiliary-impeller performance analysis and its application

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Numerical Simulation of Inner Flow Field in Centrifugal Impeller with Long, Middle and Short Blades

Optimization method investigation for centrifugal pump performance based on 3D inviscid inverse design

Impeller design criterion based on numerical simulation of stock pump flow field and its application

Influence of Impeller Structure Parameters on the Hydraulic Performance and Casting Molding of Spiral Centrifugal Pumps

Optimization Design And Inner Flow Analysis On A Medium-High Specific Speed Centrifugal Pump

A Hydraulic Performance Comparison of Centrifugal Pump Operating in Pump and Turbine Modes

Investigation of CFD Calculation Method of a Centrifugal Pump with Unshrouded Impeller

Numerical Simulation Of The Ultra-High-Speed Low-Specific-Speed Impeller Pump And Application Research In Hydraulic System

Numerical Investigation of Rotor–stator Interaction for Canned Motor Pump under Partial Load Condition

Optimization design of multistage centrifugal pump impeller by orthogonal experiment and CFD

New-type Impeller Design and Performance Prediction for Disc Pump

Numerical Prediction and Performance Experiment in an Engine Cooling Water Pump with Different Blade Outlet Widths

Influence of Blade Wrap Angle on Centrifugal Pump Performance by Numerical and Experimental Study