Abstract:Based on the theory of Multibody dynamics, the dynamical virtual prototype of whole vehicle was established, including body, frame, steering assembly, front suspension assembly and pilot bar, rear suspension assembly and pilot bar, transmission assembly and so on, which is satisfied with the maneuvering performance and ride performance analysis. Based on the virtual prototype, the law of the steady state steering characteristic of vehicle influenced by the stiffness of the front screw spring and the diameter of the stabilizer anti-roll bar was discussed. By properly increasing the stiffness of the front screw spring and the diameter of the stabilizer anti-roll bar, the steady state steering characteristic of the vehicle had been improved greatly; but with the increasing of the stiffness, the increasing rate of the side acceleration at neutral steering point decreased rapidly. Further research presented: when the stiffness of the front screw spring increased from 30N/mm to 32.5N/mm and the diameter of the stabilizer anti-roll bar increased from 20mm to 21mm, the side acceleration at neutral steering point also increased from 5.32 m/s(2) to 6.18 m/s(2), the RMS value of total weighted acceleration of driver's seats increased from 0.6027 m/s(2) to 0.6268 m/s(2). The results of intergrated measure show that the steady state steering characteristic of vehicle improves greatly, but the effect on the riding performance is not evident.

Study on the Influence of Vehicle Structural Parameters on Vehicle Handling Stability

The Study on the Handling and Stability Test of Vehicles Based on ADMS and WTK

The Influence of State Variables Variation on Vehicle Stability Criteria Under Critical Stable Condition

Simulation Analysis on Handling Stability of Suspension System of Medium Bus

Influence of Structural Nonlinearity of Suspension on Vehicle Vertical Performances

The Influence of Driving Form on Stability Control in In-Wheel-motor EV.

Study on the Effect of Stiffness Matching of Anti-Roll Bar in Front and Rear of Vehicle on the Handling Stability

Study on Active Suspension Control to ImproveVehicle Handling Stability

Study of Vehicle Handling Stability Based on MATLAB

Simulation Research on Multi-Axle Vehicle Handing and Stability Performance

Optimal allocation of tire force based on vehicle stability

Influences of Active Front Wheel Steering on Vehicle Maneuverand Stability Performance

Analysis of Vehicle Driving Stability based on Longitudinal-lateral and Vertical Unified Dynamics Model

Research on the Influence of Unsprung Mass on Vehicle Handling Stability

Study On The Improvement Of Steady State Steering Characteristic Of Vehcle

Analysis of Operating Vehicle Handling and Driving Stability Impact Elements

Study on the Effect of Chassis Parameters on Light-Bus Steady State Handling Based on ADAMS

Study of Vehicle Handing Stability Based on ADAMS/Car

Simulation analysis of influence factors on bus maneuverability and stability

Modeling and Simulation Analysis of Steering Stability Based on Vehicle Motion Simulator