The Combination of Three-Dimension Inverse Design and Optimization Methods for Helium Circulator’s Impeller Optimization in HTR

Xing Xie,Zhenlin Li,Hong Wang,Baoshan Zhu

DOI: https://doi.org/10.1007/978-3-319-97773-7_35

2018-01-01

Abstract:The working environment for Helium Circulator in HTR (high temperature gas-cooled reactor) is high temperature about 523 K and high pressure about 7 MPa. So the efficiency of Helium Circulator’s impeller is extremely important. At present, the blade loading parameters and meridional geometry parameters are obtained through the 3D inverse design methods and the widely used Bessel curves. The optimization design strategy was built by combining the 3D inverse design method, CFD analyses, Design of Experiment (DOE), Response Surface Methodology (RSM), Multi-Island Genetic Algorithm (MIGA). The optimization objective is the impeller efficiency at the design point. The input parameters are related to the blade loading, blade lean angle and the meridional channel shape. The results show that the SLOPEH, NCH, Ɵ1, and YH and Ɵ2 are the main influencing factors. The best blade loading distribution is the positive SLOPEH of high value combined with the negative SLOPES. The positive DRVT on the hub and shroud will improve the blade loading at the blade leading edge. The curve with the relative reduced curvature is beneficial to the performance of the impeller. The efficiency of the optimized impeller is 0.77% at Qd and 2.80% at 0.75Qd higher than the original impeller.