Abstract:Recently, a four-axis coordinate measuring machine (four-axis CMM), which consists of three linear axes and a single rotary axis, has been more widely used than a traditional three-axis CMM. The volumetric error influences the accuracy of the four-axis CMM. There are 27 parametric errors that contribute to the volumetric error. This study utilized a touch probe to measure the hole plate. This methodology can evaluate errors more accurately and reflect the operational conditions of the machines. The main procedures are as follows: (1) The hole plate was sequentially set up in three different planes. The touch probe was used to measure the hole plate using five different styluses. (2) The 27 parametric errors were analyzed using the coordinate deviations. The volumetric error was constructed using homogeneous transformation matrices. The volumetric error ranged from 0.35 to 1.55 μm without the single rotary axis and from 0.35 to 2.83 μm with the single rotary axis. (3) Three metrology instruments, namely a laser interferometer, an autocollimator, and a polygon-autocollimator, were used to validate the proposed methodology and verify the measured parametric errors. The absolute maximum differences compared to the laser interferometer for three parametric positioning errors and the autocollimator for six parametric rotational errors for the three linear axes were 0.56 μm and 0.54′′, respectively. Additionally, the absolute maximum difference of one parametric positioning error for the single rotary axis, compared with the polygon-autocollimator, was 0.75′′. The E n-values were 0.27, 0.54, and 0.27, respectively. These results demonstrate the effectiveness and reliability of the proposed methodology for the industry's four-axis CMMs.

Evaluation of Relative Vertical Error Motions of a Bench Center by Using an Optical Micrometer

1502 Precision Measurement of Vertical Straightness of a Roll Workpiece on an Ultra-Precision Lathe

Precision Measurement of Z -Slide Vertical Error Motion of an Ultra-Precision Lathe by Using Three-Probe Method

Survey of rolling angle measurement methods

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

Development of a simple system for simultaneously measuring 6DOF geometric motion errors of a linear guide.

Implementation and Verification of a Four-Probe Motion Error Measurement System for a Large-Scale Roll Lathe Used in Hybrid Manufacturing

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Registration Error Analysis and Evaluation in Large-Volume Metrology System

A New Optical Angle Measurement and Compensation

A line measurement method for geometric error measurement of the vertical machining center

A New Error Measurement Method to Identify All Six Error Parameters of A Rotational Axis of A Machine Tool

Geometric Analysis of Measurement Errors in a Surface Metrology Class with Closed-Loop Probes

Full-scale Measurement of CNC Machine Tools

A Measurement and Separation Method for Perpendicular Errors of Rotary Axes

An optical method based auto-collimation for measuring five degrees of freedom error motions of rotary axis

A three-degrees-of-freedom motion error measurement system based on Mach–Zehnder interferometry

Measuring of positioning, circularity and static errors of a CNC Vertical Machining Centre for validating the machining accuracy

Measuring Parametric and Volumetric Errors in a Four-Axis CMM Using a Hole Plate

Modeling, identification, and measurement of geometric errors for a rotary axis of a machine tool using a new R-test

A Geometric Error Measurement System for Linear Guideway Assembly and Calibration