Abstract:The kernel principal component analysis (KPCA) method has been widely applied in process monitoring. However, the KPCA method still has two challenging problems that need to be solved: the principal component selection problem and the problem of determining Gaussian kernel width without fault data. The principal component selection plays an important role in the performance of the KPCA method, which is determined by the cumulative contribution rate, cross-validation, average eigenvalue, etc. However, these selection methods ignore the principal components corresponding to small eigenvalues, which are still very important for fault detection. Therefore, this paper proposes a multivariate monitoring method based on the KPCA and Dual Control Chart (KPCA-DCC), which adopts a scheme of monitoring all principal components and solves the selection problem. The Gaussian kernel width is usually determined by training an appropriate coefficient to times the variable number, which may not be possible to train the coefficient in the absence of fault data while the industrial process works at the initial stage of its operation. Furthermore, different systems may have the same number of variables, and their Gaussian kernel widths should vary because of different variables’ features. Therefore, this paper proposes an empirical equation for estimating Gaussian kernel width according to data characteristics, which makes the Gaussian kernel width can be estimated without fault data. In addition, this paper also gives the detection theory of the DCC method from the probability perspective, which is not presented in the previous work. The Tennessee Eastman (TE) process and blast furnace ironmaking process are adopted to verify the effectiveness of the proposed methods.

A Process Monitoring Method Based on Dual-Parameter Optimization

Multi-mode process monitoring method based on PCA mixture model

Process monitoring and fault detection based on multivariate statistical projection analysis

Adaptive Partitioning Pca Model for Improving Fault Detection and Isolation

Fault Detection and Isolation of Non-Gaussian and Nonlinear Processes Based on Statistics Pattern Analysis and the K-Nearest Neighbor Method

Fault detection method based on kernel principal angle

Dynamic PCA-based Fault Detection and Diagnosis Analysis

A dual-parameter optimization KPCA method for process fault diagnosis

Statistical process monitoring using improved PCA with optimized sensor locations

Improved kernel PCA-based monitoring approach for nonlinear processes

Fault Detection Behavior And Performance Analysis Of Principal Component Analysis Based Process Monitoring Methods

Improved PCA with Optimized Sensor Locations for Process Monitoring and Fault Diagnosis

A Multivariate Monitoring Method Based on Kernel Principal Component Analysis and Dual Control Chart

Statistical Monitoring of Chemical Processes Based on Sensitive Kernel Principal Components

Fault detection behavior analysis of pca-based process monitoring approach

Comprehensive Monitoring of Complex Industrial Processes with Multiple Characteristics

Kernel Generalization of Multi-Rate Probabilistic Principal Component Analysis for Fault Detection in Nonlinear Process

Optimized Statistical Model for Complex Chemical Processes Monitoring

Fault Detection with Improved Principal Component Pursuit Method

Efficient Monitoring of Nonlinear Chemical Processes Based on Fault-Relevant Kernel Principal Component Subspace Construction and Bayesian Inference

Process monitoring based on independent Component Analysis-Principal Component Analysis (ICA-PCA) and similarity factors