Abstract:To accommodate the integration of renewable energy, coal-fired power plants must take on the task of peak regulation, making the low-load operation of boilers increasingly routine. Under low-load conditions, the phase transition point (PTP) of the working fluid fluctuates, leading to potential flow instability, which can compromise boiler safety. In this paper, a one-dimensional coupled dynamic model of the combustion and hydrodynamics of a supercritical boiler is developed on the Modelica/Dymola 2022 platform. The spatial distribution of key thermal parameters in the furnace and the PTP position in the water-cooled wall (WCW) are analyzed in a 660 MW supercritical boiler when parameters on the combustion side change under full-load and low-load conditions. The dynamic response characteristics of the temperature, mass flow rate, and the PTP position are investigated. The results show that the over-fire air (OFA) ratio significantly influences the flue gas temperature distribution. A lower OFA ratio increases the flue gas temperature in the burner zone but reduces it at the furnace exit. The lower OFA ratio leads to a higher fluid temperature and shortens the length of the evaporation section. The temperature difference in the WCW outlet fluid between the 20% and 60% OFA ratios is 11.7 °C under BMCR conditions and 7.4 °C under 50% THA conditions. Under the BMCR and 50% THA conditions, a 5% increase in the coal caloric value raises the flue gas outlet temperature by 32.7 °C and 35.4 °C and the fluid outlet temperature by 6.5 °C and 9.9 °C, respectively. An increase in the coal calorific value reduces the length of the evaporation section. The changes in the length of the evaporation section are −2.95 m, 2.95 m, −2.62 m, and 0.54 m when the coal feeding rate, feedwater flow rate, feedwater temperature, and air supply rate are increased by 5%, respectively.

ICOPE-15-C101 Modeling and Dynamic Simulation on a Three-Stage Feedwater Heater with Water Level Controlled

Modeling and Simulation of Circulating Water Control Loop for 900 MW Units

Simulation of Dynamic Characteristics of Supercritical Boiler Based on Coupling Model of Combustion and Hydrodynamics

Modelica-based heating surface modelling and dynamic exergy analysis of 300 MW power plant boiler

Study and Application on Dynamic Simulation Model of Single-Pressure Water-Cooled Condenser

Model and Simulation of Feed-Water Recirculation for 900MW Power Plant

A Three-Region Movable-Boundary Helical Coil Once-Through Steam Generator Model for Dynamic Simulation and Controller Design

Research On Dynamic Water Level Model Based On Supercharged Boiler

Dynamic Modeling for Utility Boiler Super-heater System and Simulation by Using Online Plant Data

Study on Water Level Control System of Natural Circulation Steam Generator

Simulation of A Once-Through, Helical-Coiled Steam Generator of High Temperature Gas-Cooled Reactor

Modeling and Simulation of the Long-term Dynamic Characteristics of a Supercritical Once-through Boiler

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

Modeling and Simulation of Secondary Loop Systems of a Pressurized Water Reactor Based on the 3KEYMASTER Platform

Transient Stress Analysis of High Pressure Heater During Feedwater Bypass Regulations

Reactor Power Control System Design and Dynamic Simulation for Load Maneuvers over Full Range and Entire Lifetime of an Integrated Supercritical CO2 Reactor Plant

Modeling and Simulation of Feedwater Control System with Multiple Once-Through Steam Generators in a Sodium-Cooled Fast Reactor (II): Control System Simulation

ICONE19-43227 THE DYNAMIC MATHEMATIC SIMULATION MODEL OF STEAM GENERATOR FOR HTR-PM

Modeling and Control Scheme Design of a Multi-Modular High Temperature Gas Cooled Reactor Cogeneration Unit

Multi-Variable Extreme Seeking Control For Efficient Operation Of Sub-Cooler Vapor Injection Trans-Critical Co2 Heat Pump Water Heater

ICONE19-43763 DESIGN AND TRANSIENT ANALYSES OF PASSIVE EMERGENCY FEEDWATER SYSTEM OF CPR1000 : PART I: AIR COOLING CONDITION