Abstract:Single-transverse mode vertical-cavity surface-emitting lasers (VCSELs) are preferred optical sources for small low-power atomic sensors, including chip-scale atomic clocks, magnetometers, and gyroscopes.When VCSEL is used as the pump source of nuclear magnetic resonance gyroscope, it is required to have high single-mode output power. Oxide aperture diameter must be sufficiently small ( 200 Ω for GaAs-based VCSEL) from the small aperture limits output power and reliability due to excessive current-induced self-heating and high current density. It is a very attractive idea to achieve high power operation of an intrinsic single mode VCSEL based on a large oxide aperture by means of epitaxial structure design without introducing additional process steps. Transverse optical confinement in oxide-confined VCSELs crucially depends on thickness of oxide layer and its position relative to standing wave. Modifying the structure reduces the overlap between the oxide layer and the standing wave as well as effective refractive index difference between core and cladding of the VCSEL that subsequently decreases of the number of transverse modes and increases the mode extension beyond oxide aperture. A 795 nm VCSEL is designed and fabricated with this concept. A cavity structure of VCSEL with gain-cavity detuning of ~10.8 nm at room temperature is adopted in this paper. The effective refractive index and the standing wave distribution of the VCSEL are calculated, and the position of the oxide layer in the epitaxial structure of the VCSEL was optimized according to the standing wave distribution. Finally, the structure with low effective refractive index difference was obtained. The proposed device achieves high single-mode operation of 4.1 mW at 80 °C, SMSR of 41.68 dB, and OPSR of 27.4 dB. VCSEL is applied in a nuclear magnetic resonance gyroscope (NMRG) system as pump source due to its excellent device performance and satisfactory test results are obtained. This paper presents a new design method of single-mode high power VCSEL and proves its feasibility through experimental results.

Design and analysis of control system for VCSEL of atomic interference magnetometer

Design of Portable Self-Oscillating VCSEL-Pumped Cesium Atomic Magnetometer

Design of Driving and Temperature Control Circuitry for VCSEL

Application of VCSEL in Bio-Sensing Atomic Magnetometers

Study on the Sensitivity of Laser-Pumped Cesium Atomic Magnetometer

A Dual Closed-Loop Drive and Control System of Photoelastic Modulator for Atomic Magnetometer

Frequency Discrimination Optimization Algorithm Design for Atomic lnterference Magnetometer

An Integrated High-Sensitivity VCSEL-Based Spin-Exchange Relaxation-Free Magnetometer With Optical Rotation Detection

A High Sensitivity Laser-Pumped Cesium Magnetometer

Design of control system in electromagnetic interference environment of discharge excimer laser

Thermal and Magnetic Field Analysis of Temperature Control Module for VCSEL Chips

Wafer-Level Optical Packaging For Chip-Scale Atomic Magnetometers

Design and Realization of Beam Collimation System for Semiconductor Laser in Atomic Magnetometer

Design and experiment of MEMS magnetic sensor

Signal-processing Electronics for Stable and Sensitive Weak-Field Atomic Vector Magnetometers.

Single-Beam Vector Atomic Magnetometer with High Dynamic Range Based on Magnetic Field Modulation

Design of Scanning Control System for Space Optical Remote Sensor

795 nm high temperature and high power operating vertical-cavity surface-emitting laser and application of atomic gyroscope

Design of VCSEL Laser Control System Based on CPT Atomic Clock

Integration of Chip-Scale SERF Atomic Magnetometers for Magnetoencephalography Measurement

Simulation of Modal Control of Metal Mode-Filtered Vertical-Cavity Surface-Emitting Laser