Abstract:Ground penetrating Radar (GPR) is an efficient tool for subsurface geophysical investigations, particularly at shallow depths. The non-destructiveness, cost efficiency, and data reliability are the important factors that make it an ideal tool for the shallow subsurface investigations. Present study encompasses; variations in central frequency of transmitting and receiving GPR antennas (Tx-Rx) have been analyzed and frequency band adjustment match filters are fabricated and tested accordingly. Normally, the frequency of both the antennas remains similar to each other whereas in this study we have experimentally changed the frequencies of Tx-Rx and deduce the response. Instead of normally adopted three pairs, a total of nine Tx-Rx pairs were made from 50MHz, 100MHz, and 200MHz antennas. The experimental data was acquired at the designated near surface geophysics test site of the Zhejiang University, Hangzhou, China. After the impulse response analysis of acquired data through conventional as well as varied Tx-Rx pairs, different swap effects were observed. The frequency band and exploration depth are influenced by transmitting frequencies rather than the receiving frequencies. The impact of receiving frequencies was noticed on the resolution; the more noises were observed using the combination of high frequency transmitting with respect to low frequency receiving. On the basis of above said variable results we have fabricated two frequency band adjustment match filters, the constant frequency transmitting (CFT) and the variable frequency transmitting (VFT) frequency band adjustment match filters. By the principle, the lower and higher frequency components were matched and then incorporated with intermediate one. Therefore, this study reveals that a Tx-Rx combination of low frequency transmitting with high frequency receiving is a better choice. Moreover, both the filters provide better radargram than raw one, the result of VFT frequency band adjustment filter is much better than CFT frequency band adjustment filter.

Ground Rolls Removal Using Simple Bandpass Filtering Combined with Signal-and-noise Orthogonalization

Ground-Roll Noise Attenuation Using a Simple and Effective Approach Based on Local Band-Limited Orthogonalization.

Ground Rolls Attenuation using Bandlimited Signal-and-Noise Orthogonalization - The OZ-25 Dataset Case Study

Ground Roll Attenuation Using Non-Stationary Matching Filtering

Blind Separation of Ground-Roll Using Interband Morphological Similarity and Pattern Coding

Ground-roll noise extraction and suppression using high-resolution linear Radon transform

The Feasibility of Ground-Roll Noise Suppression from 3d Seismic Data Using High-Resolution Linear Radon Transform

Seismic Signal Denoising Using $f-x$ Variational Mode Decomposition

Ground Roll Attenuation Using Convolutional Neural Network with Dense Connected Mechanism

Ground-roll Separation From Land Seismic Records Based on Convolutional Neural Network

Ground Roll Attenuation by Synchrosqueezed Curvelet Transform

Frequency Band Adjustment Match Filtering Based on Variable Frequency GPR Antennas Pairing Scheme for Shallow Subsurface Investigations

A self-supervised scheme for ground roll suppression

Separating Ground-Roll from Land Seismic Record Via Convolutional Neural Network

Random Noise Attenuation Using Local Signal and Noise Orthogonalization

Ground Roll Attenuation Using a Time-frequency Dependent Polarization Filter Based on S Transform

Research Note: Frequency domain orthogonal projection filtration of surface microseismic monitoring data

GROUND ROLL ATTENUATION USING IMPROVED COMPLETE ENSEMBLE EMPIRICAL MODE DECOMPOSITION

Ground roll attenuation using a time-frequency dependent polarization filter based on the S transform

Accelerated Signal-and-Noise Orthogonalization

A Ground-Roll Separation Method Based on Neural Networks with Morphological Similarity Loss