Abstract:Rechargeable lithium-ion batteries have been widely commercialized in portable electronics. However, adoption of lithium-ion batteries in more demanding applications such as electric vehicles and renewable energy storage has been hindered by capacity loss and poor performance. Although there has been enormous progress on the advancement of high capacity anode materials such as silicon, the current stage of the cathode performance is a limiting factor for the development of higher performance Li-ion batteries. Lithium iron phosphate, LiFePO 4 , (LFP) is a promising candidate material because it is inexpensive, environmentally friendly and has a high theoretical capacity (170 mAh g -1 ). Unfortunately, LFP suffers from mechanical degredations and surface instabilities that lead to capacity fade. In this work, we investigate in situ stress and strain generation in LFP composite electrodes during battery charging – discharging. Repeated lithiation and delithiation cause continuous stress and strain evolution in the electrode due to lithium intercalation and the interaction between electrode and electrolyte species. Electrodes are constrained on substrate for stress measurements, whereas free-standing electrodes are fabricated for strain measurements. Digital image correlation (DIC) is utilized to measure in situ strain generation, whereas beam curvature technique is employed to monitor in situ stress evolution in the electrode. Electrodes are cycled between 2.6 to 4.4 V at different scan rates in various electrolytes. Strain and stress derivatives are calculated with respect to applied potential. The derivatives provide remarkable information about the evolution of surface stress and structural changes in the electrode due to phase transformations. Electrochemical stiffness is calculated by combining stress and strain. Changes in stiffness during electrochemical cycling reveal underlying mechanisms governing stress and strain evolution in the LFP electrode. Acknowledgement This work was supported as part of the Center for Electrochemical Energy Science (CEES), an Energy Frontier Research Center funded by the U.S. Department of Energy, Office of Science, Basic Energy Sciences.”

Diffusion-Induced Stress in Commercial Graphite Electrodes During Multiple Cycles Measured by an in Situ Method.

In-situ Measurements of Mechanical Property and Stress Evolution of Commercial Graphite Electrode

Real-time stress measurements in lithium-ion battery negative-electrodes

Evolution of Electrochemically Induced Stress and Its Effect on the Lithium-Storage Performance of Graphite Electrode

Real-time measurements of electro-mechanical coupled deformation and mechanical properties of commercial graphite electrodes

Experimental Measurement of Stress Evolution in Silicon Carbide Composite Electrode During Electrochemical Cycling

Diffusion-Induced Transient Stresses in Li-Battery Electrodes Imaged by Electrochemical Quartz Crystal Microbalance with Dissipation Monitoring and Environmental Scanning Electron Microscopy

Effect of the Charge Rate on the Mechanical Response of Composite Graphite Electrodes: in Situ Experiment and Mathematical Analysis

Stress Evolution in Lithium-ion Composite Electrodes during Electrochemical Cycling and Resulting Internal Pressures on the Cell Casing

Experimental Investigation of Electrode Cycle Performance and Electrochemical Kinetic Performance under Stress Loading*

In Situ Measurement of Rate-Dependent Strain/stress Evolution and Mechanism Exploration in Graphene Electrodes During Electrochemical Process

One-dimensional Analysis of the Coupling Between Diffusion and Deformation in a Bilayer Electrode

Stress Evolution in Composite Silicon Electrodes during Lithiation/Delithiation

Study on Electrochemical Lithiation Stress Model of Graphite-Carbon Fiber Bilayer Electrode

In Situ Measurement of Strain and Stress Evolution in Lithium Iron Phosphate Electrodes during Electrochemical Cycling

In-situ Experimental Measurements of Lithium Concentration Distribution and Strain Field of Graphite Electrodes During Electrochemical Process

A multiplicative finite strain deformation for diffusion-induced stress: An incremental approach

Modeling and in Situ Characterization of Lithiation-Induced Stress in Electrodes During the Coupled Mechano-Electro-Chemical Process

In situ method for stress measurements in film-substrate electrodes during electrochemical processes: key role of softening and stiffening

In Situ Measurement of the Deformation and Elastic Modulus Evolution in Si Composite Electrodes During Electrochemical Lithiation and Delithiation

In-situ measurements of electrochemical stress/strain fields and stress analysis during an electrochemical process