Abstract:In this work, carrier-phase direct numerical simulation (CP-DNS) is conducted for a pulverized coal flame in a temporally evolving turbulent jet with flue gas recirculation (FGR). Detailed gas phase kinetics are considered and heavy hydrocarbon molecules up to C20 are included to accurately represent tars in the volatile matter. The structure of the pulverized coal flame is analyzed with different flamelet models considering two mixing scenarios, namely the mixing of recirculated flue gases with the other fuel or oxidizer streams. In the first model approach, the mixing of recirculated flue gases with the gaseous fuels released from the coal particle is characterized with a fuel-split-based flamelet (FLT-FS) model. In the second approach, the mixing of flue gases with the transport air is described with an oxidizer-split-based flamelet (FLT-OS) model. In total, five trajectory variables are introduced in the flamelet table to represent the pulverized coal combustion states with FGR. The suitability of the flamelet models is evaluated through an a priori analysis for both the fully ignited state, as well as (more challenging) the igniting states. Comparisons show that both the FLT-FS model and the FLT-OS model perform well in predicting the thermo-chemical quantities for the fully ignited state. The FLT-OS model performs slightly better than the FLT-FS model in predicting the gas temperature and specific species mass fractions. This is due to the fact that the partial oxidization of the gaseous fuels by the hot flue gases outside the mixing layers cannot be reproduced by the FLT-FS model. While the state at the beginning of ignition can still be accurately predicted by the FLT-OS model, discrepancies can be observed for the tar species C20H10 and the intermediate species CO at a later stage when many particles ignite and the reason for this is explained. Further analysis in the flamelet solution spaces shows that the gaseous fuels are ignited on the fuel-lean side. The time evolution of the gas temperature from the beginning of ignition to the fully ignited state can be overall characterized by both flamelet models.

Simulation of Pulverized Coal Combustion in Blast Furnace Tuyere

Numerical Simulation Study of Co-injection of Pulverized Coal and Hydrogen in the Tuyere-Raceway

Transient 3D CFD study of pulverised coal combustion and coke combustion in a blast furnace: Effect of blast conditions

Numerical investigation of hydrogen-rich gas and pulverized coal injection in the raceway of a blast furnace with lower carbon emissions

OXYGEN-ENRICHED COMBUSTION IN A HORIZONTAL FURNACE AND THREE- DIMENTIONAL NUMERICAL SIMULATION TEST THEREOF

Three-dimensional Modelling of Coal Combustion in Blast Furnace

Numerical Study on Combustion Behavior of Semi-Coke in Blast Furnace Blowpipe-Tuyere-Combustion Zone

Three-dimensional transient modelling of coal and coke co-combustion in the dynamic raceway of ironmaking blast furnaces

Numerical simulation of co-combustion characteristics of semicoke and coke breeze in an ironmaking blast furnace

Combustion behavior of co-injecting flux, pulverized coal, and natural gas in blast furnace and its influence on blast furnace smelting

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

HMB-CFD study of oxygen-enriched pulverised coal combustion in an ironmaking blast furnace

Numerical modeling of pulverized coal combustion in an oxygen-coal combustor for blast furnace

Correction To: Thermal Analysis and Kinetic Modeling of Pulverized Coal Combustion Accompanied with Coke Breeze

Numerical study of natural gas and pulverized coal co-injection into an ironmaking blast furnace

Non-isothermal Thermogravimetric Investigation on Mutual Effect Between Bituminite and Anthracite in Blends for Blast Furnace Injection

Calculation on effective heat of injected pulverized coal in blast furnace

Comprehensive Numerical Modeling of Raceways in Blast Furnaces

Numerical simulation study on the effects of co-injection of pulverized coal and SPL (Spent Pot-Lining) into the blast furnace

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

Flame Structure Analysis and Flamelet Modeling of Turbulent Pulverized Solid Fuel Combustion with Flue Gas Recirculation