Abstract:Coronavirus disease (COVID-19) is an acute infectious disease caused by severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Reverse transcription real-time fluorescent quantitative polymerase chain reaction (RT-qPCR) was the firstly authorized method for the detection of SARS-CoV-2 RNA. As this method is sensitive, specific, it has been widely recognized as the golden standard for the diagnosis of COVID-19. Unfortunately, several false-negative cases have been reported after the outbreak of COVID-19, probably due to the quality of the kits or the improper operation of RT-qPCR. Nucleic acid reference materials (RM) are the key element for the metrology traceability and quality control of SARS-CoV-2 RNA detection, but the development of RNA RM remains a challenge in the biology metrology field. Two main problems are the low stability of the RNA sample and the lack of proven absolute quantification methods. To establish the measurement traceability for SARS-CoV-2 RNA detection, a novel RNA reference material (RM) was developed. The RM is a mixed solution of 3 in vitro transcribed RNA molecules which cover different key target sequences of SARS-CoV-2 gene: The full-length of nucleoprotein (N) gene (28274-29533, GenBank: MT027064.1), the full-length of envelope protein (E) gene (26245-26472, GenBank: MT027064.1), and partial sequence of open reading frame 1ab (ORF1ab) (13321-15540, GenBank: MT027064.1). The purity of the transcribed RNA molecules was verified by a biological analyzer. The results showed that the molecular length of all the RNA molecules were consistent with our design. The clear peaks of our RNA RMs strongly demonstrated good purity. For absolute quantification of RNA RMs, we studied digital PCR (dPCR) for RNA samples. Digital PCR evenly partitioned the sample and PCR reaction solution to a very large number of units, on a microporous chip or in the liquid droplets, etc. After a PCR amplification reaction, the fluorescence signal was detected for each unit individually, with a binary readout of "0" or "1" for negative and positive results respectively. Through the statistics of positive results based on the Poisson distribution, the copy number of RNA sample was accurately determined without standard curves needed. Digital PCR has significantly higher reliability and accuracy. Mainly based on the PCR primers and probes for SARS-CoV-2 detection suggested by the Chinese CDC and WHO, we optimized the key factors of dPCR towards improved amplification efficiency. Through digital PCR measurements by 4 laboratories, the certified values of concentration (copies/mu L) were assigned for the N gene, E gene, and ORF1ab gene in the mixed RM. Single-stranded RNA is unstable and easy to be degraded by RNase in the environment, thus the optimization of RNA protectants is very important for the stability of RNA RMs. During the study of the stability, we found that a proper protector (1 mmol/L DTT and 0.5 U/L Rnase Inhibitor) can effectively increase the valid storage life of our RNA RM. Based on the latest data, the concentration of our RNA RMs was stable for at least 30 d under -80 degrees C storage and 13 d under -4 degrees C storage. In order to verify the applicability of our RNA RM in the actual virus detection process, we analyzed our RMs using 9 SARS-CoV-2 nucleic acid detection kits. These virus RNA detection kits were from different manufacturers with various detection principles, that are being applied in laboratories for virus detection. Finally, our RNA RMs showed high generalizability among 9 kits. The development of RNA RM provides the metrological basis for the quality control of SARS-CoV-2 detection kits.

Development of Reference Material of SARS-CoV-2 Genomic RNA

SARS-CoV-2 RNA Reference Materials

Development of SARS-CoV-2 packaged RNA reference material for nucleic acid testing

Validation of the Analytical Performance of Nine Commercial RT-qPCR Kits for SARS-CoV-2 Detection Using Certified Reference Material.

Reference materials for SARS-CoV-2 molecular diagnostic quality control: validation of encapsulated synthetic RNAs for room temperature storage and shipping

CCQM-P199b: Interlaboratory comparability study of SARS-CoV-2 RNA copy number quantification

Rapid and Accurate Detection of Three Genes in SARS-CoV-2 Using RT-LAMP Method

Development of a multi-recombinase polymerase amplification assay for rapid identification of COVID-19, influenza A and B

A Benchmark of methods for SARS-CoV-2 whole genome sequencing and development of a more sensitive method

Development and Characterization of Synthetic Norovirus RNA for Use in Molecular Detection Methods

The application of a testing platform in high-throughput nucleic acid detection of SARS-CoV-2

Establishment of a Reference Material in Quality Control for Use in Infectivity and Identity Assays of Recombinant COVID-19 Vaccine, in Accordance with International Standards Organization Guidance

Diagnosis with Metagenomic Next-Generation Sequencing (mNGS) technology and real-time PCR for SARS-CoV-2 Omicron detection using various nasopharyngeal swabs in SARS-CoV-2 Omicron

Analytical sensitivity and efficiency comparisons of SARS-COV-2 qRT-PCR primer-probe sets

Chinese Expert Consensus on the Nucleic Acid Detection of SARS-CoV-2

A Novel Approach to the Bioluminescent Detection of the SARS-CoV-2 ORF1ab Gene by Coupling Isothermal RNA Reverse Transcription Amplification with a Digital PCR Approach

Definition of a concentration and RNA extraction protocol for optimal whole genome sequencing of SARS-CoV-2 in wastewater (ANRS0160)

Practice and exploration of novel coronavirus nucleic acid detection in designated hospitals

Establishment of a quantitative RT-PCR detection of SARS-CoV-2 virus

CDetection.v2: One-pot assay for the detection of SARS-CoV-2

Extraction of Viral Nucleic Acids with Carbon Nanotubes Increases SARS-CoV-2 Quantitative Reverse Transcription Polymerase Chain Reaction Detection Sensitivity